An analytical and experimental investigation of the Lamb wave-mode tuning with piezoelectric wafer active sensors (PWASs) is presented. The analytical investigation assumes a PWAS transducer bonded to the upper surface of an isotropic flat plate. Shear lag transfer of tractions and strains is assumed, and an analytical solution using the spacewise Fourier transform is reviewed, closed-form solutions are presented for the case of ideal bonding (i.e., load transfer mechanism localized at the PWAS boundary). The analytical solutions are used to derive Lamb wave-mode tuning curves, which indicate that frequencies exist at which the A0 mode or the S0 mode can be either suppressed or enhanced. Extensive experimental tests that verify these tuning curves are reported. The concept of “effective PWAS dimension” is introduced to account for the discrepancies between the ideal bonding hypothesis and the actual shear-lag load transfer mechanism. The paper further shows that the capability to excite only one desired Lamb wave mode is critical for practical structural health monitoring (SHM) applications such as PWAS phased array technique (e.g., the embedded ultrasonics structural radar (EUSR)) and the time reversal process (TRP). In PWAS phased array EUSR applications, the basic assumption of the presence of a single low-dispersion Lamb wave mode (S0) is invoked since several Lamb wave modes traveling at different speeds would disturb the damage imaging results. Examples are given of correctly tuned EUSR images versus detuned cases, which illustrate the paramount importance of Lamb wave-mode tuning for the success of the EUSR method. In the TRP study, an input wave packet is reconstructed at a transmission PWAS when the signal recorded at the receiving PWAS is reversed in the time domain and transmitted back to the original PWAS. Ideally, TRP could be used for damage detection without a prior baseline. However, the application of TRP to Lamb waves SHM is impended by the dispersive and multimodal nature of the Lamb waves. The presence of more then one mode usually produces additional wave packets on both sides of the original wave packet due to the coupling of the Lamb wave modes. The PWAS Lamb wave tuning technique described in this paper is used to resolve the side packets problem. Several tuning cases are illustrated. It is found that the $30kHz$ tuning of the A0 Lamb wave mode with a 16-count smoothed tone burst leads to the complete elimination of the side wave packets. However, the elimination was less perfect for the $290kHz$ tuning of the S0 mode due to the frequency sidebands present in the tone-burst wave packet.

1.
Crawley
,
E. F.
, and
de Luis
,
J.
, 1987, “
Use Of Piezoelectric Actuators as Elements of Intelligent Structures
,”
AIAA J.
0001-1452,
25
(
10
), pp.
1373
1385
.
2.
Crawley
,
E. F.
, and
Anderson
,
E. H.
, 1990, “
Detailed Models of Piezoceramic Actuation of Beams
,”
J. Intell. Mater. Syst. Struct.
1045-389X,
1
, pp.
4
25
.
3.
Giurgiutiu
,
V.
, 2005, “
Tuned Lamb-Wave Excitation and Detection With Piezoelectric Wafer Active Sensors for Structural Health Monitoring
,”
J. Intell. Mater. Syst. Struct.
1045-389X,
16
(
4
), pp.
291
305
.
4.
Raghavan
,
A.
, and
Cesnik
,
C. E. S.
, 2004, “
Modeling of Piezoelectric-Based Lamb-Wave Generation and Sensing for Structural Health Monitoring
,”
Proc. SPIE
0277-786X,
5391
, pp.
419
430
.
5.
Raghavan
,
A.
, and
Cesnik
,
C. E. S.
, 2005, “
Piezoelectric-Actuator Excited-Wave Field Solution for Guided-Wave Structural Health Monitoring
,”
Proc. SPIE
0277-786X,
5765
, pp.
313
323
.
6.
Auld
,
B. A.
, 1990,
Acoustic Fields and Waves in Solids
,
Wiley
,
New York
, Vol.
1
and
2
.
7.
Giurgiutiu
,
V.
, and
Bao
,
J.
, 2002, “
Embedded-Ultrasonics Structural Radar for the Nondestructive Evaluation of Thin-Wall Structures
,”
Proc. of 2002 ASME International Mechanical Engineering Congress
, Nov. 17–22,
New Orleans, ASME, New York
, ASME Paper No. IMECE2002–39017.
8.
Wang
,
C. H.
,
Rose
,
J. T.
, and
Chang
,
F. K.
, 2004, “
A Synthetic Time-Reversal Imaging Method for Structural Health Monitoring
,”
Smart Mater. Struct.
0964-1726,
13
(
2
), pp.
415
423
.
9.
Yu
,
L.
, and
Giurgiutiu
,
V.
, 2006 “
Damage Detection Using Guided Waves and Piezoelectric Wafer Active Sensor Arrays
,”
Proc. of IMAC XXIV
, 30 Jan.–2 Feb., St. Louis, MO, Paper No. 170 (CD-ROM).
10.
Giurgiutiu
,
V.
,
Bao
,
J.
, and
Zhao
,
W.
, 2003 “
Piezoelectric-Wafer Active-Sensor Embedded Ultrasonics in Beams and Plates
,”
Exp. Mech.
0014-4851,
43
(
4
), pp.
428
449
.
11.
Ing
,
R. K.
, and
Fink
,
M.
, 1998, “
Time Reversal Lamb Waves
,”
IEEE Trans. Ultrason. Freq. Control
,
45
(
4
), pp.
659
663
.
12.
Kim
,
S.
,
Sohn
,
H.
,
Greve
,
D.
, and
Oppenheim
,
I.
, 2005, “
Application of a Time Reversal Process for Baseline-Free Monitoring of a Bridge Steel Girder
,” International Workshop on Structural Health Monitoring, Stanford, CA, Sept. 15–17.