This study improves the performance of a previously developed acoustic actuator in the presence of an acoustic duct system with strong pressure coupling. The speaker dynamics and the acoustic duct dynamics are first modeled separately. The two systems are then coupled, and the resulting system is modeled. A velocity sensor is developed and used in feedback compensation. The resulting speaker system has minimal magnitude and phase variation over a 20–200 Hz bandwidth. These conclusions are verified through experimental results.

1.
Birdsong, C. B., and Radcliffe, C. J., 1996, “A Compensated Actuator for an Acoustic Duct,” Masters Thesis, Michigan State University, East Lansing, MI.
2.
Bradley, P., 1995, “Active Assault on Cabin Noise,” Commercial Aviation, Vol. 77, September, 6 pp.
3.
Doak
P. E.
,
1973
, “
Excitation, Transmission and Radiation of Sound From Source Distributions in Hard-Walled Ducts of Finite Length (I): The Effects of Duct Cross-Section Geometry and Source Distributions Space-Time Pattern
,”
Journal of Sound and Vibration
, Vol.
31
, No.
1
, pp.
1
72
.
4.
Hull, A. J., Radcliffe, C. J., and Southward, S. C., 1993, “Global Active Noise Control of a One-Dimensional Acoustic Duct Using a Feedback Controller,” ASME Journal of Dynamic Systems, Measurement, and Control, Vol. 115, September.
5.
Hull, A. J., and Radcliffe, C. J., 1991, “An Eigenvalue Based Acoustic Impedance Measurement Technique,” ASME JOURNAL OF VIBRATION AND ACOUSTICS, Vol. 113, April.
6.
Hull, A. J., and Radcliffe, C. J., 1990, “State Space Representation of the Nonself-Adjoint Acoustic Duct System,” ASME JOURNAL OF VIBRATION AND ACOUSTICS, Vol. 112, October.
7.
IEEE Standard 219-1975, IEEE Standard Committee of Acoustics, Speech, and Signal Processing Group, “IEEE Recommended Practice for Loudspeaker Measurements,” IEEE std. 219–1975.
8.
Radcliffe, C. J., and Gogate, S. D., 1996, “Velocity Feedback Compensation of Electromechanical Speakers for Acoustic Applications,” International Federation of Automatic Control, Triennial World Congress, July.
9.
Radcliffe, C. J., Gogate, S. D., and Hall, A. J., 1994, “Development of an Active Acoustic Sink (AAS) for Noise Control Applications,” Active Control of Vibrations and Noise, ASME.
10.
Radcliffe, C. J., and Gogate, S. D., 1992, “Identification and Modeling Speaker Dynamics for Acoustic Control Applications,” ASME Symposium on Active Control of Noise and Vibration.
11.
Seto, W. W., 1971, Theory and Problems of Acoustics, New York, McGraw-Hill Book Company.
12.
Spiekerman, C. E., and Radcliffe, C. J., 1986, “One-Dimensional Acoustic Response with Mixed Boundary Condition: Separating Total Response into Propagating and Standing Wave Components,” Doctoral Dissertation, Michigan State University, East Lansing, MI.
13.
Warner, J., 1995, “Active Noise Control in an Off-Road Vehicle Cab,” Noise and Vibrations Worldwide, Vol. 26, No. 7 July.
This content is only available via PDF.
You do not currently have access to this content.