Experimental determination of both steady-state and dynamic performance of a journal bearing requires the use of a high precision spindle with a vanishingly small range of run-out. This was achieved by first eliminating the mechanical run-out of the spindle by grinding the journal specimen while rotating in place. Once the mechanical run-out was removed, the electrical run-out sensed by the displacement proximity-probe-transducers was also removed. Using this procedure the mechanical and electrical run-outs of a research spindle were reduced to less than 0.2 micron (10 μin.), which is better than the resolution of the data acquisition system, 1 micron (50 μin.).

Adams, M. L., Sawicki, J. T., and Capaldi, R. J., “Experimental Determination of Hydrostatic Bearing Rotordynamic Coefficients,” Proceedings, International Conference on Vibrations in Rotating Machinery, C432/145, pp. 365–374, IMechE, 1992.
Bently Nevada, Minden, Nevada.
Themac Inc., Catalog No. 104, East Rutherford, N.J.
Gilman Russell T. Company, “Gilman Dovetail Slide Assemblies,” Catalog 3000, 1985.
Schrader Bellows, Akron, Ohio.
Horattas, G. A., “Design and Implementation of a Precision Journal Grinding System as an Attachment on a Journal Bearing Test Rig,” MS Thesis, Case Western Reserve University, 1994.
Parthasaradhy, N. V., Practical Electroplating Handbook, Prentice Hall, Englewood Cliffs, 1989.
Heywood, J., Grinding Wheels and Their Uses, 2nd ed., Penton Publishing Company, Cleveland, 1942.
This content is only available via PDF.
You do not currently have access to this content.