High thermal load appears at the blade tip and casing of a gas turbine engine. It becomes a significant design challenge to protect the turbine materials from this severe situation. As a result of geometric complexity and experimental limitations, computational fluid dynamics tools have been used to predict blade tip leakage flow aerodynamics and heat transfer at typical engine operating conditions. In this paper, the effect of turbine inlet temperature on the tip leakage flow structure and heat transfer has been studied numerically. Uniform low (444 K) and high (800 K) inlet temperatures and nonuniform (parabolic) temperature profiles have been considered at a fixed rotor rotation speed (9500 rpm). The results showed that the change of flow properties at a higher inlet temperature yields significant variations in the leakage flow aerodynamics and heat transfer relative to the lower inlet temperature condition. Aerodynamic behavior of the tip leakage flow varies significantly with the distortion of turbine inlet temperature. For more realistic inlet condition, the velocity range is insignificant at all time instants. At a high inlet temperature, reverse secondary flow is strongly opposed by the tip leakage flow and the heat transfer fluctuations are reduced greatly.

1.
Chana
,
K. S.
, and
Jones
,
T. V.
, 2003, “
An Investigation of Turbine Tip and Shroud Heat Transfer
,”
ASME J. Turbomach.
0889-504X,
125
, pp.
513
520
.
2.
Chana
,
K. S.
,
Hurrion
,
J. R.
, and
Jones
,
T. V.
, 2003 “
The Design, Development and Testing of a Non-Uniform Inlet Temperature Generator for the QinetiQ Transient Turbine Research Facility
,” ASME Paper No. GT2003-38469.
3.
Povey
,
T.
,
Chana
,
K. S.
, and
Jones
,
T. V.
, 2003, “
Heat Transfer Measurements on an Intermediate-Pressure Nozzle Guide Vane Tested in a Rotating Annular Turbine Facility, and the Modifying Effects of a Non-Uniform Inlet Temperature Profile
,”
Proc. Inst. Mech. Eng., Part A
0957-6509,
217
, pp.
2041
2967
.
4.
Povey
,
T.
,
Chana
,
K. S.
,
Jones
,
T. V.
, and
Hurrion
,
J.
, 2007, “
The Effect of Hot-Streaks on HP Vane Surface and Endwall Heat Transfer: An Experimental and Numerical Study
,”
ASME J. Turbomach.
0889-504X,
129
, pp.
32
43
.
5.
Saxer
,
A. P.
, and
Giles
,
M. B.
, 1994, “
Predictions of Three-Dimensional Steady and Unsteady Inviscid Transonic Stator/Rotor Interaction With Inlet Radial Temperature Nonuniformity
,”
ASME J. Turbomach.
0889-504X,
116
, pp.
347
357
.
6.
Joslyn
,
D.
, and
Dring
,
R.
, 1992, “
Three-Dimensional Flow in an Axial Turbine: Part 2—Profile Attenuation
,”
ASME J. Turbomach.
0889-504X,
114
, pp.
71
78
.
7.
He
,
L.
,
Menshikova
,
V.
, and
Haller
,
B. R.
, 2004, “
Influence of Hot Streak Circumferential Length-Scale in Transonic Turbine Stage
,” ASME Paper No. GT2004-53370.
8.
Qingjun
,
Z.
,
Huishe
,
W.
,
Xiaolu
,
Z.
, and
Jianzhong
,
X.
, 2007, “
Numerical Investigation on the Influence of Hot Streak Temperature Ratio in a High Pressure Stage of Vaneless Counter-Rotating Turbine
,”
Int. J. Rotating Mach.
1023-621X,
2007
, pp.
56097
.
9.
Sharma
,
O. P.
,
Stetson
,
G. M.
,
Daniels
,
W. A.
,
Greitzer
,
E. M.
,
Blair
,
M. F.
, and
Dring
,
R. P.
, 1997, “
Impact of Periodic Unsteadiness on Performance and Heat Load in Axial Flow Turbomachines
,” NASA Lewis Research Center, Final Report No. NASA-CR-202319.
10.
An
,
B. -T.
,
Liu
,
J. -J.
, and
Jiang
,
H. -D.
, 2009, “
Numerical Investigation on Unsteady Effects of Hot Streak on Flow and Heat Transfer in a Turbine Stage
,”
ASME J. Turbomach.
0889-504X,
131
(
3
), pp.
031015
.
11.
Phutthavong
,
P.
,
Hassan
,
I.
, and
Lucas
,
T.
, 2008, “
Unsteady Numerical Investigation of Blade Tip Leakage, Part 1: Time-Averaged Results
,”
J. Thermophys. Heat Transfer
0887-8722,
22
(
3
), pp.
464
473
.
12.
Phutthavong
,
P.
,
Hassan
,
I.
, and
Lucas
,
T.
, 2008, “
Unsteady Numerical Investigation of Blade Tip Leakage, Part 2: Time-Dependent Parametric Study
,”
J. Thermophys. Heat Transfer
0887-8722,
22
, pp.
474
484
.
13.
Krishnababu
,
K.
,
Hodson
,
H. P.
,
Dawes
,
W. N.
,
Lock
,
G. D.
,
Hannis
,
J.
, and
Whitney
,
C.
, 2007, “
Aero-Thermal Investigations of Tip Leakage Flow in Axial Flow Turbines: Part 2—Effects of Relative Casing Motion
,”
ASME 52nd International Gas Turbine and Aerospace Congress
, Montreal, QC, Canada, May.
14.
Kim
,
S. I.
,
Rahman
,
M. H.
, and
Hassan
,
I.
, 2009, “
Effect of Turbine Inlet Temperature on Blade Tip Leakage Flow and Heat Transfer
,” ASME Paper No. GT2009-60143.
You do not currently have access to this content.