Gas turbines for aircraft are designed for operation with a clean inlet air flow. This ideal operational condition is often violated during take-off and landing, where the probability of particle ingestion is high, with sand and dirt being the most commonly observed foreign particles. Current research on particle ingestion has identified several mechanisms that contribute to performance degradation in the turbine: erosion of internal and external surfaces, and flow blockages of film-cooling holes and internal cooling passages. The focus of the study given in this paper is to present a method that identifies the motion of foreign particles within an internal ribbed passage. The method uses a high-resolution, flow field interrogation method known as time-resolved digital particle image velocimetry (TRDPIV). Observations from the two-phase flows showed that particle collisions occurred more frequently on the upstream surface of the ribs, especially in the inlet region. Results from these collisions included substantial particle breakup, and a particle rebounding phenomenon between the upper and lower walls. Comparisons are made to large eddy simulation predicted particle trajectories indicating some agreement, as well as phenomena that are not predicted due to the inherent assumption of the modeling.
Skip Nav Destination
Article navigation
April 2011
Research Papers
A Method for Identifying and Visualizing Foreign Particle Motion Using Time-Resolved Particle Tracking Velocimetry
N. D. Cardwell,
N. D. Cardwell
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
Search for other works by this author on:
P. P. Vlachos,
P. P. Vlachos
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
Search for other works by this author on:
K. A. Thole
K. A. Thole
Department of Mechanical and Nuclear Engineering,
Pennsylvania State University
, University Park, PA 16802
Search for other works by this author on:
N. D. Cardwell
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
P. P. Vlachos
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
K. A. Thole
Department of Mechanical and Nuclear Engineering,
Pennsylvania State University
, University Park, PA 16802J. Turbomach. Apr 2011, 133(2): 021021 (10 pages)
Published Online: October 26, 2010
Article history
Received:
July 26, 2009
Revised:
September 4, 2009
Online:
October 26, 2010
Published:
October 26, 2010
Citation
Cardwell, N. D., Vlachos, P. P., and Thole, K. A. (October 26, 2010). "A Method for Identifying and Visualizing Foreign Particle Motion Using Time-Resolved Particle Tracking Velocimetry." ASME. J. Turbomach. April 2011; 133(2): 021021. https://doi.org/10.1115/1.4001187
Download citation file:
104
Views
Get Email Alerts
Cited By
Related Articles
Modeling of the Onset of Gas Entrainment From a Stratified Two-Phase Region Through Branches on a Curved Surface
J. Fluids Eng (July,2006)
Two-Phase Flow Simulation of Mist Film Cooling on Turbine Blades With Conjugate Internal Cooling
J. Heat Transfer (October,2008)
Considerations of a Double-Wall Cooling Design to Reduce Sand Blockage
J. Turbomach (July,2010)
Effect of Variable Heating Load on the Refrigerant Distribution of a Dual Cold-Plate System
J. Electron. Packag (June,2009)
Related Proceedings Papers
Related Chapters
Liquid Cooled Systems
Thermal Management of Telecommunication Equipment, Second Edition
Advanced Cooling Technologies II: Two-Phase Flow Cooling
Thermal Management of Microelectronic Equipment, Second Edition
Advanced Cooling Technologies II: Two-Phase Flow Cooling
Thermal Management of Microelectronic Equipment