Measurements of the local heat transfer distribution on smooth and roughened surfaces under an array of angled impinging jets are presented. The test rig is designed to simulate impingement with crossflow in one direction. Jet angle is varied between 30, 60, and as measured from the target surface, which is either smooth or randomly roughened. Liquid crystal video thermography is used to capture surface temperature data at five different jet Reynolds numbers ranging between 15,000 and 35,000. The effect of jet angle, Reynolds number, gap, and surface roughness on heat transfer and pressure loss is determined along with the various interactions among these parameters.
Issue Section:
Technical Papers
1.
Florschuetz
, L. W.
, Berry
, R. A.
, and Metzger
, D. E.
, 1980, “Periodic Streamwise Variations of Heat Transfer Coefficients for Inline and Staggered Arrays of Circular Jets with Crossflow of Spent Air
,” ASME J. Heat Transfer
0022-1481, 102
, pp. 132
–137
.2.
Florschuetz
, L. W.
, Truman
, C. R.
, and Metzger
, D. E.
, 1981, “Streamwise Flow and Heat Transfer Distributions for Jet Array Impingement with Crossflow
,” ASME J. Heat Transfer
0022-1481, 103
, pp. 337
–342
.3.
Florschuetz
, L. W.
, Metzger
, D. E.
, and Su
, C. C.
, 1984, “Heat Transfer Characteristics for Jet Array Impingement with Initial Crossflow
,” ASME J. Heat Transfer
0022-1481, 106
, pp. 34
–41
.4.
Florschuetz
, L. W.
, and Isoda
, Y.
, 1983, “Flow Distributions and Discharge Coefficient Effects for Jet Array Impingement with Initial Crossflow
,” ASME J. Eng. Power
0022-0825, 105
, pp. 296
–304
.5.
Andrews
, G. E.
, and Hussain
, C. I.
, 1986, “Full Coverage Impingement Heat Transfer: The Influent of Channel Height
,” Proceedings of the 8th International Heat Transfer Conference
, Vol. 3
, pp. 1205
–1211
.6.
Gillespie
, D. R. H
, Wang
, Z.
Ireland
, P. T.
, and Kohler
, S. T.
, 1998, “Full Surface Local Heat Transfer Coefficient Measurements in a Model of an Integrally Cast Impingement Cooling Geometry
,” ASME J. Turbomach.
0889-504X, 120
, pp. 92
–99
.7.
Son
, C.
, Gillespie
, D.
, Ireland
, P.
, and Dailey
, G.
, 2001, “Heat Transfer and Flow Characteristics of an Engine Representative Impingement Cooling System
,” ASME J. Turbomach.
0889-504X, 123
, pp. 154
–160
.8.
Huang
, Y.
, Ekkad
, S. V.
, and Han
, J.
, 1998, “Detailed Heat Transfer Distribution under an Array of Orthogonal Impinging Jets
,” J. Thermophys. Heat Transfer
0887-8722, 12
(1
), pp. 73
–79
.9.
Perry
, K. P.
, 1954, “Heat Transfer by Convection from a Hot Gas Jet to a Plane Surface
,” Proc. Inst. Mech. Eng.
0020-3483, Vol. 168
, pp 775
–784
.10.
Trabold
, T. A.
, and Obot
, N. T.
, 1987, “Impingement Heat Transfer Within Array of Circular Jets: Part II—Effects of Crossflow in the Presence of Roughness Elements
,” ASME J. Turbomach.
0889-504X, 109
, pp. 594
–601
.11.
Haiping
, C.
, Jingyu
, Z.
, and Taiping
, H.
, 1998, “Experimental Investigation on Impingement Heat Transfer From Rib Roughened Surface within Array of Circular Jet: Effect of Geometric Parameters
,” ASME Paper No. 98-GT-208.12.
Failla
, G.
, Bishop
, E. H.
, and Liburdy
, J. A.
, 1996, “Enhanced Jet Impingement Heat Transfer with Crossflow at Low Reynolds Numbers
,” ASME National Heat Transfer Conference, HTD-Vol. 324
, pp. 107
–113
.13.
Johnson
, R. A.
, Loprinzo
, A. J.
, Lee
, C.
, Abuaf
, N.
, Hasz
, W. C.
, and Morton
, L. M.
, 2003, “Method & Apparatus for Enhancing Heat Transfer in a Combustor Liner for a Gas Turbine
.” U. S. Patent No. 6,526,756 B2 (Mar. 4, 2003).14.
El-Gabry
, L. A.
, 2003, “Local Heat Transfer Distribution on Smooth and Roughened Surfaces under an Array of Angled Impinging Jets
,” Ph.D. thesis, Rensselaer Polytechnic Institute.15.
Johnson
, R. A.
, 1994, Miller and Freund’s Probability and Statistics for Engineers
, Prentice–Hall
, Englewood Cliffs, NJ.16.
Shapiro
, A. H.
, 1953, The Dynamics and Thermodynamics of Compressible Fluid Flow
, Vol. 1
, Wiley
, New York.17.
Kline
, S. J.
, and McClintock
, F. A.
, 1953, “Describing Uncertainties in Single-Sample Experiments
,” Mech. Eng. (Am. Soc. Mech. Eng.)
0025-6501, 75
, pp. 3
–8
.18.
Florschuetz
, L. W.
, Metzger
, D. E.
, Takeuchi
, D. I.
, and Berry
, R. A.
, 1980, “Multiple Jet Impingement Heat Transfer Characteristic—Experimental Investigation of In-Line and Staggered Arrays With Crossflow
,” NASA-CR-3217, Arizona State University, Tempe, AZ.19.
Kercher
, D. M.
, and Tabakoff
, W.
, 1970, “Heat Transfer by a Square Array of Round Air Jets Impinging Perpendicular to a Flat Surface Including the Effect of Spent Air
,” ASME J. Eng. Power
0022-0825, 92
, pp. 73
–82
.Copyright © 2005
by American Society of Mechanical Engineers
You do not currently have access to this content.
