This paper presents a study of the three-dimensional flow field within the blade rows of a high-pressure axial flow steam turbine stage. Half-delta wings were fixed to a rotating hub to simulate an upstream rotor passage vortex. The flow field is investigated in a low-speed research turbine using pneumatic and hot-wire probes downstream of the blade row. The paper examines the impact of the delta wing vortex transport on the performance of the downstream blade row. Steady and unsteady numerical simulations were performed using structured three-dimensional Navier-Stokes solver to further understand the flow field. The loss measurements at the exit of the stator blade showed an increase in stagnation pressure loss due to the delta wing vortex transport. The increase in loss was 21% of the datum stator loss, demonstrating the importance of this vortex interaction. The transport of the stator viscous flow through the rotor blade row is also described. The rotor exit flow was affected by the interaction between the enhanced stator passage vortex and the rotor blade row. Flow underturning near the hub and overturning towards the midspan was observed, contrary to the classical model of overturning near the hub and underturning towards the midspan. The unsteady numerical simulation results were further analyzed to identify the entropy producing regions in the unsteady flow field.

1.
Hodson
,
H. P.
,
1985
, “
Measurements of Wake Generated Unsteadiness in the Rotor Passages of Axial Flow Turbines
,” ASME J. Eng. Gas Turbines Power, 107.
2.
Chaluvadi
,
V. S. P.
,
Kalfas
,
A. I.
,
Banieghbal
,
M. R.
,
Hodson
,
H. P.
, and
Denton
,
J. D.
,
2001
, “
Blade Row Interaction in a High Pressure Turbine
,”
J. Propul. Power
,
17
, pp.
892
901
.
3.
Chaluvadi
,
V. S. P.
,
Kalfas
,
A. I.
,
Hodson
,
H. P.
,
Ohyama
,
H.
, and
Watanabe
,
E.
,
2003
, “
Blade Row Interaction in a High Pressure Steam Turbine
,”
ASME J. Turbomach.
,
125
, pp.
14
24
.
4.
Sharma, O. P., Renaud, E., Butler, T. L., Milsaps, K., Dring, R. P., and Joslyn, H. D., 1988, “Rotor-Stator Interaction in Multistage Axial Flow Turbines,” AIAA Paper No. 88-3013.
5.
Boletis
,
E.
, and
Sieverding
,
C. H.
,
1991
, “
Experimental Study of the Three Dimensional Flow Field in a Turbine Stator Preceded by a Full Stage
,”
ASME J. Turbomach.
,
113
, p.
1
1
.
6.
Walraevens, R. E., Gallus, H. E., Jung, A. R., Mayer, J. F., and Stetter, H., 1998, “Experimental and Computational Study of the Unsteady Flow in a 1.5 Stage Axial Turbine With Emphasis on the Secondary Flow in the Second Stator,” ASME Paper 98-GT-254.
7.
Ristic
,
D.
,
Lakshminarayana
,
B.
, and
Chu
,
S.
,
1999
, “
Three-Dimensional Flow field Downstream of an Axial-Flow Turbine Rotor
,”
J. Propul. Power
,
15
(
2
), pp.
334
344
.
8.
Sharma, O. P., Pickett, G. F., and Ni, R. H., 1990, “Assessment of Unsteady Flows in Turbines,” ASME Paper No. 90-GT-150.
9.
Chaluvadi, V. S. P., Kalfas, A. I., and Hodson, H. P., 2003, “Vortex Generation and Interaction in a Steam Turbine,” presented at 5th European Conference on Turbomachinery, Mar. 18–21, Prague, Czech Republic.
10.
Chaluvadi, V. S. P., 2000, “Blade-Vortex Interactions in High Pressure Steam Turbines,” Ph.D. thesis, Department of Engineering, Cambridge University, England.
11.
Champagne
,
F. H.
,
Schleicher
,
C. A.
, and
Wehrmann
,
O. H.
,
1967
,
J. Fluid Mech.
,
28
, p.
153
153
.
12.
Denton, J. D., 1986, “The Use of a Distributed Body Force to Simulate Viscous Effects in 3D Flow Calculations,” ASME Paper 86-GT-144.
13.
Denton, J. D., 1990, “The Calculation of Three Dimensional Viscous Flow Through Multistage Turbomachinery,” ASME Paper 90-GT-19.
14.
Denton, J. D., 1999, “Multistage Turbomachinery Flow Calculation Program (MULTIP99)—User’s Manual,” Whittle Laboratory, University of Cambridge.
15.
Kuroumaru
,
M.
,
Inoue
,
M.
,
Higki
,
T.
,
Abd-Elkhalek
,
F. A.-E.
, and
Ikui
,
T.
,
1982
, “
Measurement of Three Dimensional Flow Field Behind an Impeller by Means of Periodic Multi-sampling With a Slanted Hotwire
,”
Bull. JSME
,
25
(
209
), pp.
1674
1681
.
16.
Goto, A., 1991, “Three Dimensional Flow and Mixing in an Axial Flow Compressor With Different Rotor Tip Clearances,” ASME Paper 91-GT-89.
17.
Arts, T., Boerrigter, H., Carbonaro, M., Charbonnier, J. M., Degrez, G., Olivari, D., Reithmuller, M. L., and Van den Braembussche, R. A., 1994, “Measurement Techniques in Fluid Dynamics,” VKI LS-1994-01.
18.
Denton, J. D., 1993, “Loss Mechanisms in Turbomachines,” IGTI Gas Turbine Scholar Lecture, ASME Paper 93-GT-435.
19.
Binder
,
A.
,
1985
, “
Turbulence Production Due to Secondary Vortex Cutting in a Turbine Rotor
,”
ASME J. Eng. Gas Turbines Power
,
107
, pp.
1039
1046
.
You do not currently have access to this content.