Turbine blade cooling experiments often use mixtures of air and a heavy gas $CO2,SF6$ to simulate coolant/mainstream density ratios. If the mixing of the mainstream with the coolant ejected from the blade is of interest, then it may be necessary to determine the spatial distribution of the heavy gas concentration in the flowfield. Commercial analyzers are too slow and have other disadvantages when used for this purpose. To meet this special need, a device has been developed to monitor the heavy gas concentration continuously in a small sample stream by determining the speed of sound in the sample. Together with the temperature of the sample, the information is sufficient to determine the concentration. The device measures the time of propagation for an ultrasonic burst transverse to the stream. The temperature of the gas contained in the device is controlled and measured. Calibration with several gas mixtures (air and $CO2,$$SF6,$ He) has shown an uncertainty $Cmeas−Ctrue$ of 2 percent over the full concentration range of 0–100 percent for $CO2$ and $SF6.$ The device is operable in the pressure range from −50 to 100 kPa gage and in the temperature range from 0°C to 40°C. The instrument is rugged and will survive in noisy, turbulent environments. [S0889-504X(00)01202-2]

1.
Brown
,
G. L.
, and
Rebollo
,
M. R.
,
1972
, “
A Small, Fast-Response Probe to Measure Composition of a Binary Gas Mixture
,”
AIAA J.
,
10
, No.
5
, pp.
649
652
.
2.
Zucrow, M. J., and Hoffman, J. D., 1976, “Gas Dynamics,” Vol. I, Ch. 1–15, Wiley, New York.
3.
Jena
,
A.
,
Magori
,
V.
, and
Russwurm
,
W.
,
1993
, “
Ultrasound Gas-Flow Meter for Household Application
,”
Sens. Actuators A
,
37–38
, pp.
135
140
.
4.
Sajben, M., and Crafton, D. A., 1997, “Low-Cost Measurement of Mass Fraction in Binary Gas Mixtures,” AIAA Paper No. 97-0602.
5.
Nagy
,
P. B.
, and
Blaho
,
G.
,
1994
, “
Experimental Measurement of Surface Stiffness on Water-Saturated Porous Solids
,”
J. Acoust. Soc. Am.
,
95
, No.
2
, pp.
828
835
.
6.
Strilka, T., 1999, “A Development of an Ultrasonic Method for Mass Fraction Measurement in Binary Gas Mixtures,” MS thesis, The University of Cincinnati, Department of Aerospace Engineering and Engineering Mechanics.
7.
Coleman, H. W., and Steele, W. G., 1989, Experimentation and Uncertainty Analysis for Engineers, Wiley, New York.