The performance requirements of centrifugal compressors usually include a broad operating range between surge and choke. This becomes increasingly difficult to achieve as increased pressure ratio is demanded. In order to suppress the tendency to surge and extend the operating range at low flow rates, inlet swirl is often considered through the application of inlet guide vanes. To generate high inlet swirl angles efficiently, an inlet volute has been applied as the swirl generator, and a variable geometry design developed in order to provide zero swirl. The variable geometry approach can be applied to increase the swirl progressively or to switch rapidly from zero swirl to maximum swirl. The variable geometry volute and the swirl conditions generated are described. The performance of a small centrifugal compressor is presented for a wide range of inlet swirl angles. In addition to the basic performance characteristics of the compressor, the onsets of flow reversals at impeller inlet are presented, together with the development of pressure pulsations, in the inlet and discharge ducts, through to full surge. The flow rate at which surge occurred was shown, by the shift of the peak pressure condition and by the measurement of the pressure pulsations, to be reduced by over 40 percent.

1.
Rodgers
C.
,
1977
, “
Impeller stalling as influenced by diffusion limitations
,”
ASME Journal of Fluids Engineering
, Vol.
99
, p.
84
84
.
2.
Rodgers, C., 1990, “Centrifugal compressor inlet guide vanes for increased surge margin,” ASME Paper No. 90-GT-158.
3.
Simon
H.
, et al.,
1987
, “
Improvements in the performance characteristics of single-stage and multistage centrifugal compressors by simultaneous adjustments of inlet guide vanes and diffuser vanes
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
109
, p.
41
41
.
4.
Steinke, R. J., and Crouse, J. E., 1967, “Preliminary analysis of the effectiveness of variable geometry guide vanes to control rotor-inlet flow conditions,” NASA TN-D 3823.
5.
Whitfield
A.
, et al.,
1975
, “
Experimental and theoretical performance of a radial flow turbocharger compressor with inlet prewhirl
,”
Proc. I. Mech. E
, Vol.
189
, p.
177
177
.
6.
Whitfield
A.
,
Doyle
M. D. C.
, and
Firth
M. R.
,
1993
, “
Design and performance of a high-pressure ratio turbocharger compressor. Part 1: Design considerations. Part 2: Experimental performance
,”
Proc. I. Mech. E
, Vol.
207
, p.
115
115
.
7.
Whitfield
A.
, and
Mohd Noor
A. B.
,
1994
, “
Design and performance of vaneless volutes for radial inflow turbines. Part 1. Non-dimensional conceptual design considerations
,”
Proc. I. Mech. E J. Power and Energy, Part A
, Vol.
208
, pp.
199
211
.
8.
Williams, P. R., 1989, “An examination of the methods used to vary the output of centrifugal compressors with particular reference to part-load efficiency,” Proc. I. Mech. E Euro Conf. Developments in Industrial Compressors, p. 37.
This content is only available via PDF.
You do not currently have access to this content.