The results of a computation, performed with a three-dimensional Navier–Stokes computation at ONERA, have been averaged in the blade-to-blade direction; the spatial fluctuations around the averaged flow variables have also been determined. It has then been possible to estimate all terms in the average components of the momentum equations. The comparison of the two-dimensional balances of these three equations shows that the shear stress plays a minor role in the momentum balance, except on the dissipation of the passage vortex kinetic energy downstream of the blade trailing edges. The kinetic energy of the spanwise component of the velocity spatial fluctuations has a very strong influence on the radial pressure gradient; it introduces a convection effect. This is a key effect for all these balances.

1.
Adkins
G. G.
, and
Smith
L. H.
,
1982
, “
Spanwise Mixing in Axial-Flow Turbomachines
,”
ASME Journal of Engineering for Power
, Vol.
104
, pp.
97
110
.
2.
Buleev, N. I., 1962, “Theoretical Model of the Mechanism of Turbulent Exchange in Fluid Flows,” Teploperedacha, Moscow, USSR, pp. 64–98; AERE translation 957, Atomic Energy Research Establishment, Harwell, United Kingdom, 1963.
3.
Cambier, L., Couaillier, V., and Veuillot, J. P., 1988, “Re´solution nume´rique des e´quations de Navier–Stokes a` l’aide d’une me´thode multigrille,” La Recherche Ae´rospatiale, No. 1988-2, pp. 23–42.
4.
Dawes
W. N.
,
1987
, “
A Numerical Analysis of the Three-Dimensional Viscous Flow in a Transonic Compressor Rotor and Comparison With Experiment
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
109
, pp.
83
90
.
5.
Denton, J. D., Hodson, H. P., and Dominy, R. G., 1990, “Test Case E/CA-7: Subsonic Turbine Cascade LA,” in: “Test Cases for Computation of Internal Flows in Aero-engine Components,” AGARD-AR-275, Fottner, ed., pp. 124–138.
6.
Dring
R. P.
,
1993
, “
Radial Transport and Momentum Exchange in an Axial Compressor
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
115
, pp.
477
486
.
7.
De Ruyck, J., and Hirsch, C., 1988, “A Radial Mixing Computation Method,” ASME Paper No. 88-GT-68.
8.
Escande, B., and Cambier, L., 1991, “Validation du Code CANARI par le Calcul de l’Ecoulement Tridimensionnel Turbulent dans un Distributeur de Turbine,” AGARD CP 510, San Antonio, TX.
9.
Gallimore
S. J.
, and
Cumpsty
N. A.
,
1986
, “
Spanwise Mixing in Multistage Axial Flow Compressors: Part 1—Experimental Investigations; Part II—Through Flow Calculations Including Mixing
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
108
, pp.
2
16
.
10.
Hirsch
C.
, and
Dring
R. P.
,
1987
, “
Through-Flow Models for Mass and Momentum-Averaged Variables
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
109
, pp.
362
370
.
11.
Hirsch, C., 1990, Numerical Computation of Internal and External Flows, Wiley.
12.
Leboeuf, F., and Brochet, J., 1985, “The Use of a Secondary Flow Computation in the Compressor Design Process,” Three Dimensional Flow Phenomena in Fluid Machinery, Hamed, Herring, and Povinelli, eds., ASME FED-Vol. 32.
13.
Leylek
J. H.
, and
Wisler
D. C.
,
1991
, “
Mixing in Axial-Flow Compressors: Conclusions Drawn From Three-Dimensional Navier–Stokes Analyses and Experiments
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
113
, pp.
139
160
.
14.
Michel, R., Quemard, C., and Durant, R., 1969, “Application d’un sche´ma de longueur de me´lange a` l’e´tude des couches limites turbulentes d’e´quilbres,” ONERA NT No. 154.
This content is only available via PDF.
You do not currently have access to this content.