Skip Nav Destination
Article navigation
Discussions
Closure to “Discussion of ‘Ways to Improve the Drilling Effectiveness of Rock Bits by a Tribological Method’” (1988, ASME J. Tribol., 110, p. 216)
Yi-Ling Wang,
Yi-Ling Wang
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Search for other works by this author on:
Hong Luo
Hong Luo
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Search for other works by this author on:
Yi-Ling Wang
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
Hong Luo
Shanghai Jiao Tong University, Shanghai, People’s Republic of China
J. Tribol. Apr 1988, 110(2): 216 (1 pages)
Published Online: April 1, 1988
Article history
Online:
October 29, 2009
Connected Content
This is a commentary to:
Nonlinear Gross Response Analysis of a Lumbar Motion Segment in Combined Sagittal Loadings
Citation
Wang, Y., and Luo, H. (April 1, 1988). "Closure to “Discussion of ‘Ways to Improve the Drilling Effectiveness of Rock Bits by a Tribological Method’” (1988, ASME J. Tribol., 110, p. 216)." ASME. J. Tribol. April 1988; 110(2): 216. https://doi.org/10.1115/1.3261587
Download citation file:
58
Views
Get Email Alerts
Cited By
Stochastic Performance of Journal Bearing With Two-Layered Porous Bush—A Machine Learning Approach
J. Tribol (October 2023)
Monitoring Wear of a Deep Groove Ball Bearing Using Ultrasonic Reflection
J. Tribol (October 2023)
Experimental Investigation and Machine Learning Modeling of Wear Characteristics of AZ91 Composites
J. Tribol (October 2023)
Related Articles
Modeling Flow of a Biviscous Fluid From Borehole Into Rock Fracture
J. Appl. Mech (January,2006)
Methods to Estimate the Rock Strength and Tooth Wear While Drilling With Roller-Bits—Part 2: Insert Bits
J. Energy Resour. Technol (September,2002)
Methods to Estimate the Rock Strength and Tooth Wear While Drilling With Roller-Bits—Part 1: Milled-Tooth Bits
J. Energy Resour. Technol (September,2002)
Proposed Practical Methods to Estimate Rock Strength and Tooth Wear While Drilling With Roller-Cone Bits
J. Energy Resour. Technol (December,2004)
Related Proceedings Papers
Related Chapters
Introduction
Mechanics of Drillstrings and Marine Risers
Study and Construction of Experiment Table of Drilling at Any Position of Rock Sample
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Fabrication of Single Crystal Diamonds∕Cemented Carbide Composite Cutter for Rock Drilling
Geological Engineering: Proceedings of the 1 st International Conference (ICGE 2007)