Journal misalignment usually exists in journal bearings that affect nearly all the bearings static and dynamic characteristics including minimum oil film thickness, maximum oil film pressure, maximum oil film temperature, oil film stiffness, and damping. The main point in this study is to provide a comprehensive analysis on the oil film pressure, oil film temperature, oil film thickness, load-carrying capacity, oil film stiffness, and damping of journal bearing with different misalignment ratios and appropriately considering the turbulent and thermo effects based on solving the generalized Reynolds equation and energy equation. The results indicate that the oil thermo effects have a significant effect on the lubrication of misaligned journal bearings under large eccentricity ratio. The turbulent will obviously affect the lubrication of misaligned journal bearings when the eccentricity or misalignment ratio is large. In the present design of the journal bearing, the load and speed become higher and higher, and the eccentricity and misalignment ratio are usually large in the operating conditions. Therefore, it is necessary to take the effects of journal misalignment, turbulent, and thermal effect into account in the design and analysis of journal bearings.
Issue Section:
Technical Brief
Keywords:
Fluid film lubrication
References
1.
Jang
, J. Y.
, and Khonsari
, M. M.
, 2010
, “On the Behavior of Misaligned Journal Bearings Based on Mass-Conservative Thermohydrodynamic Analysis
,” ASME J. Tribol.
, 132
(1
), pp. 1
–13
.10.1115/1.40002802.
McKee
, S. A.
, and McKee
, T. R.
, 1932
, “Pressure Distribution in the Oil Film of Journal Bearings
,” Trans. ASME
, 54
, pp. 149
–165
.3.
DuBois
, G. B.
, Ocvirk
, F. W.
, and Wehe
, R. L.
, 1957
, “Properties of Mis-Aligned Journal Bearings
,” Trans. ASME
, 79
, pp. 1205
–1212
.4.
Pinkus
, O.
, and Bupara
, S. S.
, 1979
, “Analysis of Misaligned Groove Journal Bearing
,” ASME J. Lubr. Technol.
, 101
(4
), pp. 503
–509
.10.1115/1.34534025.
Buckholz
, R. H.
, and Lin
, J. F.
, 1986
, “The Effect of Journal Bearing Mis-alignment on Load and Cavitation for Non-Newtonian Lubricants
,” ASME J. Tribol.
, 108
(4
), pp. 645
–654
.10.1115/1.32612956.
Vijayaraghavan
, D.
, and Keith
, T. G.
, 1989
, “Effect of Cavitation on the Performance of Grooved Mis-Aligned Journal Bearing
,” Wear
, 134
(2
), pp. 377
–397
.10.1016/0043-1648(89)90137-37.
Vijayaraghavan
, D.
, and Keith
, T. G.
, 1990
, “Analysis of a Finite Misaligned Journal Bearing Considering Cavitation and Starvation Effects
,” ASME J. Tribol.
, 112
(1
), pp. 60
–67
.10.1115/1.29202318.
Banwait
, S. S.
, Chandrawat
, H. N.
, and Adithan
, M.
, 1998
, “Thermo Hydrodynamic Analysis of Misaligned Plain Journal Bearing
,” Proceedings of First Asia International Conference on Tribology
, Beijing, pp. 35
–40
.9.
Monmousseau
, P.
, and Fillon
, M.
, 1999
, “Analysis of Static and Dynamic Misaligned Tilting-Pad Journal Bearings
,” Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol.
, 213
(4
), pp. 253
–261
.10.1243/135065099154264010.
Guha
, S. K.
, 2000
, “Analysis of Steady-State Characteristics of Misaligned Hydrodynamic Journal Bearings With Isotropic Roughness Effect
,” Tribol. Int.
, 33
(1
), pp. 1
–12
.10.1016/S0301-679X(00)00005-011.
Xu
, H.
, Mian
, O.
, and Parker
, D.
, 2001
, “Performance of a Gear Pump Bearing Taking Into Account Elastic Deflection of Both Housing and Shaft
,” Proceedings of the Second World Tribology Congress
, Vienna.12.
Bouyer
, J.
, and Fillon
, M.
, 2002
, “An Experimental Analysis of Misalignment Effects on Hydrodynamic Plain Journal Bearing Performances
,” ASME. J. Tribol.
, 124
(2
), pp. 313
–319
.10.1115/1.140218013.
Gulwadi
, S. D.
, and Shrimpling
, G.
, 2003
, “Journal Bearing Analysis in Engines Using Simulation Techniques
,” SAE
Technical Paper No.2003-01-0245.10.4271/2003-01-024514.
Boedo
, S.
, and Booker
, J. F.
, 2004
, “Classic Bearing Mis-Alignment and Edge Loading: A Numerical Study of Limiting Cases
,” ASME. J. Tribol.
, 126
(3
), pp. 535
–541
.10.1115/1.173924115.
Pierre
, I.
, Bouyer
, J.
, and Fillon
, M.
, 2004
, “Thermohydrodynamic Behavior of Misaligned Plain Journal Bearings: Theoretical and Experimental Approaches
,” STLE Tribol. Trans.
, 47
(4
), pp. 594
–604
.10.1080/0569819049051397416.
Bouyer
, J.
, and Fillon
, M.
, 2005
, “Influence of Deformation Effects on a Misaligned Plain Journal Bearing
,” Proceedings of Third World Tribology Congress
, pp. 105
–106
.17.
Sun
, J.
, and Gui
, C. L.
, 2004
, “Hydrodynamic Lubrication Analysis of Journal Bearing Considering Mis-Alignment Caused by Shaft Deformation
,” Tribol. Int.
, 37
(10
), pp. 841
–848
.10.1016/j.triboint.2004.05.00718.
Sun
, J.
, Gui
, C. L.
, and Li
, Z. Y.
, 2005
, “Influence of Journal Misalignment Caused by Shaft Deformation Under Rotational Load on Performance of Journal Bearing
,” Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol.
, 219
(4
), pp. 275
–283
.10.1243/135065005X3393719.
Mark
, D.
, 2000
, “Vibration Characteristics of Industrial Gas Turbines
,” ORBIT Third Quarter
, pp. 18
–21
.20.
Wang
, X. L.
, 1999
, “Thermohydrodynamic Lubrication Analysis of Main Bearing for Internal Combustion Engine Considering Surface Roughness
,” Ph.D. thesis, Tsinghua University, Beijing, China.21.
Bouard
, L.
, Fillon
, M.
, and Frene
, J.
, 1996
, “Comparison Between Three Turbulent Models—Application to Thermohydrodynamic Performances of Tilting- pad Journal Bearing
,” Tribol. Int.
, 29
(1
), pp. 11
–18
.10.1016/0301-679X(95)00028-322.
Kumar
, A.
, and Mishra
, S. S.
, 1996
, “Stability of Rigid Rotor in Turbulent Hydrodynamic Worn Journal Bearings
,” Wear
, 193
(1
), pp. 25
–30
.10.1016/0043-1648(95)06654-323.
Constantinescu
, V. N.
, 1968
, “Lubrication in Turbulent Regime
,” U.S. Atomic Energy Commission/Division of Technical Information, National Bureau of Standards, U.S. Department of Commerce, Report No. AEC-tr-6959, p. 22151
.24.
Sun
, J.
, and Deng
, M.
, 2010
, “Thermohydrodynamic Lubrication Analysis of Misaligned Plain Journal Bearing With Rough Surface
,” ASME J. Tribol.
, 132
(1
), pp. 41
–48
.10.1115/1.400051525.
Constantinescu
, V. N.
, 1973
, “Basic Relationships in Turbulent Lubrication and Their Extension to Include Thermal Effects
,” ASME J. Lubr. Technol.
, 95
(2
), pp. 47
–54
.10.1115/1.345175526.
Chun
, A. M.
, 2004
, “Thermohydrodynamic Lubrication Analysis of High-Speed Journal Bearing Considering Variable Density and Variable Specific heat
,” Tribol. Technol.
, 37
(5
), pp. 405
–414
.10.1016/j.triboint.2003.12.00927.
Gazley
, J. C.
, 1958
, “Heat-Transfer Characteristics of the Rotational Axial Flow Between Concentric Cylinders
,” Trans. ASME
, 80
, pp. 79
–90
.28.
Khonsari
, M. M.
, and Wang
, S. H.
, 1991
, “On the Fluid–Solid Interaction in Reference to Thermoelastohydrodynamic Analysis of Journal Bearings
,” ASME J. Tribol.
, 113
(2
), pp. 398
–404
.10.1115/1.2920635Copyright © 2015 by ASME
You do not currently have access to this content.
