This paper presents a numerical study comparing the performance of air bearing slider form-factors. The air bearing slider and air bearing surface (ABS) design has gone through drastic changes in recent years in order to achieve the performance required by lower flying heights. In the past, improvements have been seen by scaling down the form-factors of air bearing sliders. The pico form-factor 1.25×1mm has been successfully used for several generations of products and the question arises—should the form-factor be scaled down further? The dynamic characteristics and flying-height modulation (FHM) performance of two different ABS designs in the pico and femto 0.82×0.66mm form-factors were numerically investigated. It was found that for the smaller form-factor designs, greater damping of the air bearing film and slider body system was achieved but with an undesirable decrease in modal frequencies. However, depending on the ABS design, beneficial dynamic properties can be achieved by scaling down the form-factor from pico to femto. Maximizing the total air bearing force (the sum of negative and positive) with a design featuring a large number of transverse pressure gradients can obtain high stiffness and damping. Geometric FHM was also investigated using both sinusoidal disk waviness and an actual measured disk topography. It was found that the FHM depends not only on the form-factor, but also on the ABS design. For long disk waviness wavelengths (longer than the slider body length, L), the FHM is proportional to Lβ where β was found to be between 2.6 and 4; hence, FHM is dependent on form-factor. For short disk waviness wavelengths, the FHM is a function of the ABS design and flying attitude and not form-factor. A disk waviness wavelength of 3 mm demarks the transition above which the FHM is a function of form-factor and below which the FHM is a function of the ABS design and the superposition of these two effects compose the geometric FHM. Simulations with an actual measured disk topography showed that the femto form-factor exhibited 22–32 percent less FHM than the pico form-factor for a similar design. However, by changing the ABS design, 35–40 percent less FHM was achieved within the same form-factor. By scaling down a pico slider to a femto slider, we do not necessarily achieve enhanced overall performance. Significant performance improvements in the pico form-factor can be attained if the ABS is properly designed. However, in designing a dynamically stable and low FHM air bearing slider a femto slider ultimately yields better performance when care is taken in designing the ABS.

1.
Mee, C. D., and Daniel, E. D., 1990, Magnetic Recording Handbook: Technology and Applications, McGraw-Hill, Inc., New York, pp. 450–528.
2.
Wood
,
R.
,
2000
, “
The Feasibility of Magnetic Recording at 1 Terabit per Square Inch
,”
IEEE Trans. Magn.
,
36
(
1
), pp.
36
42
.
3.
Thornton
,
B. H.
,
Nayak
,
A.
, and
Bogy
,
D. B.
, “
Flying Height Modulation Due to Disk Waviness of Sub-5 nm Flying Height Air Bearing Sliders
,”
ASME J. Tribol.
,
124
, pp.
762
770
.
4.
Thornton
,
B. H.
,
Bogy
,
D. B.
, and
Bhatia
,
C. S.
,
2002
, “
The Effects of Disk Morphology on Flying Height Modulation: Experiment and Simulation
,”
IEEE Trans. Magn.
,
38
(
1
), pp.
107
111
.
5.
Zhu, L.-Y., Bogy, D. B., 1989, “Head-Disk Spacing Fluctuation due to Disk Topography in Magnetic Recording Hard Disk Files,” Tribology and Mechanics of Magnetic Storage Systems, STLE Special Publication, SP-26, pp. 160–167.
6.
Zeng
,
Q. H.
, and
Bogy
,
D. B.
,
1999
, “
Stiffness and Damping Evaluation of Air Bearing Sliders and New Designs with High Damping
,”
ASME J. Tribol.
,
121
,
341
347
.
7.
Hu
,
Y.
, and
Bogy
,
D. B.
,
1997
, “
Flying Characteristics of a Slider over Textured Surface Disks
,”
IEEE Trans. Magn.
,
33
(
5
), pp.
3196
3198
.
8.
White
,
J. W.
,
1991
, “
The Transverse Pressure Contour Slider: Flying Characteristics and Comparisons with Taper-Flat and Cross-Cut Type Sliders
,”
Adv. Inf. Storage Syst.
,
3
, pp.
1
14
.
9.
White, J. W., 1987, “Dynamic Response of the Transverse Pressure Contour Slider,” Tribology and Mechanics of Magnetic Storage Systems, STLE Special Publication, SP-22, pp. 72–82.
10.
Tanaka
,
H.
,
Yonemura
,
S.
, and
Tokisue
,
H.
,
2001
, “
Slider Dynamics During Continuous Contact with Textured and Smooth Disks in Ultra Low Flying Height
,”
IEEE Trans. Magn.
,
37
(
2
), pp.
906
911
.
You do not currently have access to this content.