The dry sliding behavior of various 2xxx and 7xxx aluminum alloys with and without nickel-aluminum bronze-coatings were evaluated for industrial sheave wheel applications involving steel cables. In order to simulate the wear caused by a cable within the sheave groove, wear tests were conducted using a pin-on-ring wear test configuration. For these tests, the various aluminum alloys were worn against a 387 steel using an interfacial pressure of 13.9 MPa and a sliding velocity of 9.42 m/s. Results indicated that for the conditions studied, the 7xxx aluminum alloys exhibited a superior wear resistance relative to the 2xxx aluminum alloys with and without nickel-aluminum bronze coatings. A wear mode analysis based upon optical and electron microscopy revealed material removal mechanisms dominated by adhesive and abrasive wear. Moreover, a statistical analysis indicated a potential relationship between wear rate and a combination of yield strength, solidus temperature and post-wear inverse hardness.
The Dry Sliding Behavior of Aluminum Alloys Against Steel in Sheave Wheel Applications
Contributed by the Tribology Division for publication in the ASME JOURNAL OF TRIBOLOGY. Manuscript received by the Tribology Division December 28, 1999; revised manuscript received October 20, 2000. Associate Editor: M. D. Bryant.
- Views Icon Views
- Share Icon Share
- Search Site
Goldman, R. W., Segall, A. E., and Conway, J. C. (October 20, 2000). "The Dry Sliding Behavior of Aluminum Alloys Against Steel in Sheave Wheel Applications ." ASME. J. Tribol. October 2001; 123(4): 676–681. https://doi.org/10.1115/1.1339981
Download citation file:
- Ris (Zotero)
- Reference Manager