In this study, the lump growth model, described in an accompanying paper (de Rooij and Schipper, 2000) is validated by means of experiments performed on a deepdrawing simulator. In the experiments, the influence of material and roughness properties of both sheet and tool on the galling behavior is determined. For these experiments, a deepdrawing simulator and a selection of aluminum and zinc coated sheets with several (coated) deepdrawing tools are used. Good agreement is found between results of the lump growth model and the sheet metal forming experiments.
Analysis of Material Transfer From a Soft Workpiece to a Hard Tool: Part II—Experimental Verification of the Proposed Lump Growth Model
Contributed by the Tribology Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for presentation at the STLE/ASME Tribology Conference, Seattle, WA, October 1–4. Manuscript received by the Tribology Division Feb. 29, 2000; revised manuscript received June 29, 2000. Paper No. 2000-TRIB-24. Associate Editor. T. C. Ovaert.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
de Rooij, M. B., and Schipper, D. J. (June 29, 2000). "Analysis of Material Transfer From a Soft Workpiece to a Hard Tool: Part II—Experimental Verification of the Proposed Lump Growth Model ." ASME. J. Tribol. July 2001; 123(3): 474–478. https://doi.org/10.1115/1.1308023
Download citation file:
- Ris (Zotero)
- Reference Manager