An experimental investigation of the surface topography, nanoindentation hardness, and nanowear characteristics of carbon thin films was conducted using atomic force and point contact microscopy. Hydrogenated carbon films of thickness 5, 10, and 25 nm were synthesized using a sputtering technique. Atomic force microscopy images obtained with silicon nitride tips of nominal radius less than 20 nm demonstrated that the carbon films possessed very similar surface topographies and root-mean-square roughness values in the range of 0.7–1.1 nm. Nanoindentation and nanowear experiments performed with diamond tips of radius equal to about 20 nm revealed a significant enhancement of the hardness and wear resistance with increasing film thickness. High-resolution surface imaging indicated that plastic flow was the dominant deformation process in the nanoindentation experiments. The carbon wear behavior was strongly influenced by variations in the film thickness, normal load, and number of scanning cycles. For a given film thickness, increasing the load caused the transition from an atomic-scale wear process, characterized by asperity deformation and fracture, to severe wear consisting of plowing and cutting of the carbon films. Both the critical load and scanning time for severe wear increased with film thickness. Below the critical load, the wear rate decreased with further scanning and the amount of material worn off was negligibly small, while above the critical load the wear rate increased significantly resulting in the rapid removal of carbon. The observed behavior and trends are in good qualitative agreement with the results of other experimental and contact mechanics studies.
Skip Nav Destination
Article navigation
October 1995
Research Papers
Nanoscale Indentation Hardness and Wear Characterization of Hydrogenated Carbon Thin Films
B. Wei,
B. Wei
Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Search for other works by this author on:
K. Komvopoulos
K. Komvopoulos
Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Search for other works by this author on:
B. Wei
Department of Mechanical Engineering, University of California, Berkeley, CA 94720
K. Komvopoulos
Department of Mechanical Engineering, University of California, Berkeley, CA 94720
J. Tribol. Oct 1995, 117(4): 594-601 (8 pages)
Published Online: October 1, 1995
Article history
Received:
June 2, 1994
Revised:
December 16, 1994
Online:
January 24, 2008
Citation
Wei, B., and Komvopoulos, K. (October 1, 1995). "Nanoscale Indentation Hardness and Wear Characterization of Hydrogenated Carbon Thin Films." ASME. J. Tribol. October 1995; 117(4): 594–601. https://doi.org/10.1115/1.2831521
Download citation file:
Get Email Alerts
Static Characteristics of Hybrid Water-Lubricated Herringbone Groove Journal Bearing
J. Tribol (April 2025)
Related Articles
Nanoscale Indentation Hardness and Wear Characterization of Hydrogenated Carbon Thin Films
J. Tribol (April,1996)
Nanotribological and Nanomechanical Properties of Ultrathin Amorphous Carbon Films Synthesized by Radio Frequency Sputtering
J. Tribol (July,2001)
Related Proceedings Papers
Related Chapters
Surface Analysis and Tools
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
Understanding the Problem
Design and Application of the Worm Gear
On the Evaluation of Thermal and Mechanical Factors in Low-Speed Sliding
Tribology of Mechanical Systems: A Guide to Present and Future Technologies