... surface methodology SAH = Solar air heater two-sided curvilinear rib thermal characteristic optimization response surface methodology extended surfaces/fins forced convection heat transfer enhancement References [1] Dawn , S. , Tiwari , P. K. , Goswami...

..., Al-Ketan et al. [ 17 ] designed a heat sink based on TPMS topology, evaluating its performance in a forced convection basin. They found that the zigzagging and complexity of Diamond structure channels increased the convective heat transfer coefficient by up to 32% under specific flow conditions...

...Shubham J. Sathe; Mahima Kaushik; Raj M. Manglik; Milind A. Jog Steady, periodically fully developed forced convection through three-dimensional perforated sinusoidal wavy fin cores with uniform wall temperature is computationally investigated. Constant property airflow (Pr ≈ 0.71) with a Reynolds...

...: [email protected] 26 07 2024 19 12 2024 23 12 2024 29 01 2025 collector efficiency dryer drying rate moisture ratio phase change material solar collector forced convection radiative heat transfer thermal systems Drying is crucial in preserving food slices...

...-Mode Forced Convection Solar Dryer for Drying Thymus and Mint ,” Energy Convers. Manage. , 74 , pp. 109 – 116 . 10.1016/j.enconman.2013.05.006 [9] Kansara , R. , Pathak , M. , and Patel , V. K. , 2021 , “ Performance Assessment of Flat-Plate Solar Collector With Internal Fins...

.... , Sadrhosseini , H. , and Hannani , S. K. , 2022 , “ Heat Transfer Intensification of Turbulent Forced Convection by Inserting Discontinuous Twisted Tapes in a Wavy Tube; Hydrothermal and Thermodynamics Analysis ,” Chem. Eng. Process—Process Intensif. , 181 , p. 109137 . 10.1016/j.cep.2022.109137...

..., the temperature increase is smaller but remains uniform, indicating that the hot spots can be mitigated. electronic cooling extended surfaces/fins forced convection thermal systems Modern electronics continue to miniaturize while transistor density increases, resulting in significant rises in heat...

...: [email protected] Email: [email protected] Email: [email protected] 03 07 2024 23 09 2024 25 09 2024 15 10 2024 permanent magnet synchronous motor water channel cooling structure design temperature field distribution optimized design forced convection heat...

... Nusselt number friction factor energy systems forced convection heat recovery heat transfer enhancement thermal systems Graphical Abstract Figure 23 04 2024 10 07 2024 19 07 2024 29 08 2024 1 Corresponding author. Email: [email protected] Email...

... Investigation on Heat Transfer of Supercritical CO 2 in Heated Helically Coiled Tubes ,” J. Supercrit. Fluids , 99 , pp. 112 – 120 . 10.1016/j.supflu.2015.02.001 [26] Jackson , J. , and Hall , W. , 1979 , Turbulent Forced Convection in Channels and Bundles , Hemisphere Publishing...

... diameter-to-tube diameter ratio falls in a range 2 ≤ D f / D ≤ 3. In addition to porous wrappings, researchers have also utilized porous fins to investigate the thermal behavior of heat exchangers [ 41 , 42 ]. A numerical investigation on forced convective heat transfer from a cylinder fitted...

... of the convection mode. Therefore, the temperature profile of the fluid is very similar to that of the solid plate thermal profile. However, as the flow increased, the forced convection mode started to dominate the heat transfer more than the conduction mode did. This was clearly observed in the thermal profile...

...: [email protected] Email: [email protected] Email: [email protected] 07 09 2023 12 03 2024 16 03 2024 08 04 2024 Graphical Abstract Figure parallel-plate channel metal foams wall heat transfer heat transfer enhancement forced convection porous media...

... bubbles particles and droplets extended surfaces/fins forced convection thermophysical properties The ignition of combustible fluid leakage on the hot surface of an aircraft is a major cause of flight fires [ 1 ]. This issue has become a focal point in the aircraft industry [ 2 , 3...

... heat exchanger MCHE wavy channel microheat exchanger friction factor j factor calculation. conduction forced convection heat and mass transfer heat exchangers heat-transfer enhancement micro/nanoscale heat transfer Microchannel heat exchangers (MCHEs) are being used in an increasing...

... 2024 Graphical Abstract Figure energy efficiency forced convection heat and mass transfer film cooling counter rotating vortex pair common flow down configuration common flow up configuration The power output of a gas turbine is determined by its intake temperature. When...

.... The branched wavy heat sinks (BWHSs) under forced convection with water/Al 2 O 3 under the Re = 100–500 have been investigated. The computational approach utilized for the simulations of the BWHSs was confirmed using experimental data from Ref. [ 46 ]. This validation ensures the correctness...

... ribs turning vane extended surfaces/fins forced convection gas turbine heat transfer heat transfer enhancement Gas turbines are extensively used for aircraft propulsion and power generation, and the turbine inlet temperature has been steadily rising to enhance the power output and thermal...

[email protected] 20 08 2023 19 11 2023 20 11 2023 18 12 2023 impingement cooling artificial neural networks multi-layer perceptron heat transfer augmentation helically coiled jet average Nusselt number stagnation Nusselt number experimental techniques forced convection heat...

... techniques forced convection heat exchangers Ministry of Education, Culture, Sports, Science, and Technology 10.13039/501100001700 JP23K13266 Plate heat exchangers (PHEs) are widely applied in heating, ventilation, and air-conditioning (HVAC), power plants, and exhaust heat recovery...