1-8 of 8
Keywords: correlation
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. April 2022, 14(4): 041011.
Paper No: TSEA-21-1147
Published Online: August 6, 2021
...Xiaohuan Li; Xiande Fang; Zufen Luo; Lu Xu; Hongfeng Shang Compact plate-fin heat exchangers with serrated channels have been widely used in a variety of industrial systems. However, few correlations for flow boiling heat transfer in serrated channels are available in the literature...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. June 2021, 13(3): 031024.
Paper No: TSEA-20-1360
Published Online: November 6, 2020
... thermal model is applied before and during activation of the external heater to provide estimates of the fluid heat transfer coefficient h. The results are correlated with the volume flowrate Q and the fluid temperature T wc . Several different parameter estimation codes are used to estimate the optimal...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. June 2021, 13(3): 031018.
Paper No: TSEA-20-1107
Published Online: November 5, 2020
... presents a brief review about effects of various operating and geometrical factors on frictional pressure drop during flow boiling in plate heat exchangers. Experimental data points of frictional pressure drop were collected from the previous literature to develop a general correlation. The database...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. December 2020, 12(6): 061006.
Paper No: TSEA-19-1488
Published Online: June 18, 2020
... 1.7–4.0 mm. Based on the database a brief comparison between several previous correlations are discussed. A new prediction method for flow boiling heat transfer coefficient is developed by multiple regression analysis and modifying an existing correlation. A criterion proposed by Li and Wu about...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. October 2020, 12(5): 051020.
Paper No: TSEA-18-1042
Published Online: April 2, 2020
... out for Reynolds number ratios (Re r /Re a ) inferior and superior to 1. Results revealed that increasing the number of turns avoids the back-mixing phenomenon and thus improves the heat transfer. In this study, the establishment of correlation is determined with the introduction of dimensionless...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Thermal Sci. Eng. Appl. December 2017, 9(4): 041001.
Paper No: TSEA-16-1061
Published Online: March 21, 2017
... studies. The fRe value for smaller fin spacing shows a maximum with clearances, while the same for higher fin spacing remains the same or increases with clearances. Finally, overall Nusselt number and friction factor are well correlated with the governing parameters of the problem. 1 Corresponding...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Thermal Sci. Eng. Appl. December 2009, 1(4): 041003.
Published Online: May 19, 2010
... for straight a capillary tube, and it was observed that the coiling of the capillary tube reduced the mass flow rate in the spiral tube in the range of 9–18% as compared with that in the straight capillary tube. A generalized nondimensional correlation for the prediction of the mass flow rates of various...