This study was conducted to investigate the effect of cavitation on liquid jet atomization characteristics in nozzles of different length to diameter (L/D) ratios. For this purpose, a spray test facility with an ambient pressure chamber was constructed, and sprays were recorded using a high-speed camera for a wide range of conditions, which provided complete characterization of the orifice flow fields and the emerging jet. Collapse length measurements are provided and indicate the complex nature of the nozzle flow. Extensive discharge coefficient measurements for each nozzle are also presented. Finally, the influence of the length to diameter ratio on cavitation and subsequently on the spray structure is also addressed.
Issue Section:
Research Papers
References
1.
Bergwerk
, W.
, 1959
, “Flow Pattern in Diesel Nozzle Spray Holes
,” Proc. Inst. Mech. Eng.
, 173
(1
), pp. 655
–660
.2.
Chaves
, H.
, Knapp
, M.
, Kubitzek
, A.
, Obermeier
, F.
, and Schneider
, T.
, 1995
, “Experimental Study of Cavitation in the Nozzle Hole of Diesel Injectors Using Transparent Nozzles
,” SAE
Technical Paper No. 950290.3.
Soteriou
, C.
, Andrews
, R.
, and Smith
, M.
, 1995
, “Direct Injection Diesel Sprays and the Effect of Cavitation and Hydraulic Flip on Atomization
,” SAE
Technical Paper No. 950080.4.
Arcoumanis
, C.
, and Gavaises
, M.
, 1998
, “Linking Nozzle Flow With Spray Characteristics in a Diesel Fuel Injection System
,” Atomization Sprays
, 8
(3
), pp. 307
–347
.5.
Schmidt
, D. P.
, and Corradini
, M. L.
, 2001
, “The Internal Flow of Diesel Fuel Injector Nozzles: A Review
,” Int. J. Engine Res.
, 2
(1
), pp. 1
–22
.6.
Nishimura
, A.
, and Assanis
, D. N.
, 2000
, “A Model for Primary Diesel Fuel Atomization Based on Cavitation Bubble Collapse Energy
,” Eighth International Conference on Liquid Atomization & Spray Systems (ICLASS), Pasadena, CA, July 16–20, pp. 16
–20
.7.
Baumgarten
, C.
, Stegemann
, J.
, and Merker
, G. P.
, 2002
, “A New Model for Cavitation Induced Primary Break-Up of Diesel Sprays
,” 18th Annual Conference on Liquid Atomization & Spray Systems (ILASS
), Zaragoza, Spain, Sept. 9–11, Vol. 9
, p. 11
.8.
Som
, S.
, and Aggarwal
, S. K.
, 2010
, “Effects of Primary Breakup Modeling on Spray and Combustion Characteristics of Compression Ignition Engines
,” Combust. Flame
, 157
(6
), pp. 1179
–1193
.9.
Abderrezzak
, B.
, and Huang
, Y.
, 2016
, “A Contribution to the Understanding of Cavitation Effects on Droplet Formation Through a Quantitative Observation on Breakup of Liquid Jet
,” Int. J. Hydrogen Energy
, 41
(35
), pp. 15821
–15828
.10.
Birouk
, M.
, and Lekic
, N.
, 2009
, “Liquid Jet Breakup in Quiescent Atmosphere: A Review
,” Atomization Sprays
, 19
(6
), pp. 501
–528
.11.
Cleary
, V.
, Bowen
, P.
, and Witlox
, H.
, 2007
, “Flashing Liquid Jets and Two-Phase Droplet Dispersion—I: Experiments for Derivation of Droplet Atomisation Correlations
,” J. Hazard. Mater.
, 142
(3
), pp. 786
–796
.12.
Kay
, P. J.
, Bowen
, P. J.
, and Witlox
, H. W.
, 2010
, “Sub-Cooled and Flashing Liquid Jets and Droplet Dispersion—II: Scaled Experiments and Derivation of Droplet Size Correlations
,” J. Loss Prev. Process Ind.
, 23
(6
), pp. 849
–856
.13.
Suh
, H. K.
, and Lee
, C. S.
, 2008
, “Effect of Cavitation in Nozzle Orifice on the Diesel Fuel Atomization Characteristics
,” Int. J. Heat Fluid Flow
, 29
(4
), pp. 1001
–1009
.14.
Tamaki
, N.
, Shimizu
, M.
, Nishida
, K.
, and Hiroyasu
, H.
, 1998
, “Effects of Cavitation and Internal Flow on Atomization of a Liquid Jet
,” Atomization Sprays
, 8
(2
), pp. 179
–197
.15.
Wang
, S. L.
, Huang
, Y.
, Zou
, T.
, and Liu
, Z. L.
, 2014
, “Effects of Cavitation in Nozzle on Spray
,” J. Propul. Technol.
, 35
(3
), pp. 397
–402
(in Chinese).16.
Zhang
, Z. B.
, Huang
, T.
, and Zhuangyun
, L.
, 2002
, “Experimental Investigations of Cavitation Effects on Flow Characteristics of Small Orifices and Valves in Water Hydraulics
,” Chin. J. Mech. Eng.
, 15
(4
), pp. 380–384.17.
Payri
, R.
, Salvador
, F. J.
, Gimeno
, J.
, and De la Morena
, J.
, 2009
, “Study of Cavitation Phenomena Based on a Technique for Visualizing Bubbles in a Liquid Pressurized Chamber
,” Int. J. Heat Fluid Flow
, 30
(4
), pp. 768
–777
.18.
Yu
, B.
, Fu
, P. F.
, Zhang
, T.
, and Zhou
, H. C.
, 2013
, “The Influence of Back Pressure on the Flow Discharge Coefficients of Plain Orifice Nozzle
,” Int. J. Heat Fluid Flow
, 44
, pp. 509
–514
.Copyright © 2017 by ASME
You do not currently have access to this content.