Abstract
Introducing the emulsion of an oil into the flame of an atomic absorption spectrophotometer, instead of introducing the solution of the oil or ash extract, may afford an advantage. A number of these “emulsification” procedures are summarized schematically.
Issue Section:
Technical Notes
Bibliography
1.
Algeo
, J. D.
and Denton
, M. B.
, “A Comparison of Three Methods for the Determination of Wear Metals in Lubricating Oils: Direct Introduction—ICP, Solvent Dilution—AAS, and Ashing—AAS
,” Department of Science and Technology Report AD-A113-468, Department of Chemistry, University of Arizona
, Tucson, AZ.2.
Burrows
, J. A.
, Heerdt
, J. C.
, and Willis
, J. B.
, “Determination of Wear Metals in Used Lubricating Oils by Atomic Absorption Spectrometry
,” Analytical Chemistry
0003-2700, Vol. 37
, No. 4
, 04
1965
, pp. 579
-582
.3.
“
Determination by Atomic Absorption Spectrophotometry of Zinc, Calcium, Barium and Magnesium, in Mineral Oil Products: Emulsion Method
,” Chemical Abstracts
0009-2258, Vol. 82
, 75292y, 1975
;also in
Erdoel Und Kohle
, Vol. 27
, No. 8
, 08
1974
, pp. 435
-436
.4.
“
Use of Emulsions in Flame Emission Spectrophotometry. II. Direct Determination of Calcium in Lubricating Oils
,” Chemical Abstracts
0009-2258, Vol. 94
, 86772d, 1981
;also in
Analysis
, Vol. 8
, No. 9
, 1980
, pp. 448 and 451.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.