Abstract
The porosity and pore size distributions of cement pastes of water/cement ratios of 0.35 and 0.55 were measured by high pressure (50,000 psi) mercury porosimetry. Measurements were made on pastes hydrated from 8 hours to 90 days. The variation of mercury porosity with maturity was found to correlate well with generally held concepts of the hydration of cement paste.
Differences in the pore size distributions between pastes of different water/cement ratio lie mainly in the region of large pores.
Issue Section:
Research Papers
References
1.
Winslow
, D. N.
and Diamond
, S.
, Journal of Materials, JMLSA
, Vol. 5
, 1970
, p. 564.2.
Powers
, T. C.
and Brownyard
, T. L.
, “Studies of the Physical Properties of Hardened Portland Cement Paste
,” Bulletin 22
, Portland Cement Association
, Chicago
, 1948
.3.
Powers
, T. C.
in Proceedings of the Fourth International Symposium on the Chemistry of Cement
, National Bureau of Standards Monograph
, Vol. 2
, 1960
, p. 577.4.
Feldman
, R. F.
and Sereda
, P. J.
, Engineering Journal
0013-8029 Vol. 53
, 1970
, p. 53.5.
Feldman
, R. F.
, Cement and Concrete Research
0008-8846, Vol. 2
, 1972
, p. 123.6.
Verbeck, George, Bulletin
197
, Portland Cement Association
, Skokie, Illinois, 1966
.7.
Orr
, Clyde
Jr., Powder Technology
0032-5910, Vol. 3
, 1969/70, p. 117.8.
Washburn
, E. W.
, Proceedings of the National Academy of Science
, Vol. 7
, 1921
, p. 115.9.
Hill
, R. D.
, Transactions of the British Ceramic Society
, Vol. 59
, 1960
, p. 189.10.
Meyer
, H. I.
, Journal of Applied Physics
0021-8979 https://doi.org/10.1063/1.1721319, Vol. 24
, 1953
, p. 510.11.
Quynn
, R. G.
, Textile Research Journal
0040-5175, Vol. 33
, 1963
, p. 21.12.
Steinberg
M.
, et al, “Concrete-Polymer Materials
,” BNL 50134, T-509, 1968
.13.
Diamond
, Sidney
, Cement and Concrete Research
0008-8846, Vol. 1
, 1971
, p. 531.14.
Beaudoin
, J. J.
, Cement and Concrete Research
0008-8846, Vol. 2
, 1972
, p. 146.15.
Diamond
, Sidney
and Dolch
, W. L.
, Journal of Colloid and Interface Science
0021-9797, Vol. 38
, 1972
, p. 234.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.