The work detailed in this paper is focused on updating and refining a coning rotor wind turbine concept. The coning rotor combines the load shedding properties of flapping hinges with gross change in rotor area, via large coning angles, to affect increased energy capture at nominally constant system cost. Previous studies have indicated that the large cost of energy reductions is possible, compared to the state-of-the-art machines then, particularly for abundant but presently uneconomic low-wind sites. Almost ten years later, the fundamentals of the design remain sound, but bear reevaluation relative to current machines, both exploiting modern power electronics and control technology. The coning rotor was never optimized in its own right, so an integrated design tool suitable for human and computer refinement of the design has been developed. Incorporated into the tool is a corrected blade element momentum method that more properly accounts for coned rotor aerodynamics. A discussion of the development of coning rotors is presented, along with a comparison to present operational strategies. Results obtained for nondimensionalized rotors and specific machine optimization studies are presented, followed by a discussion of further issues to be addressed.
Skip Nav Destination
e-mail: curranc@uvic.ca
e-mail: mjp@eng.cam.ac.uk
Article navigation
August 2008
Research Papers
Updating and Optimization of a Coning Rotor Concept
Curran Crawford,
Curran Crawford
Department of Mechanical Engineering,
e-mail: curranc@uvic.ca
University of Victoria
, PO Box 3055 STN CSC, Victoria, BC, V8W 3P6, Canada
Search for other works by this author on:
Jim Platts
Jim Platts
Institute for Manufacturing, Department of Engineering,
e-mail: mjp@eng.cam.ac.uk
Cambridge University
, Mill Lane, Cambridge, CB2 1RX, UK
Search for other works by this author on:
Curran Crawford
Department of Mechanical Engineering,
University of Victoria
, PO Box 3055 STN CSC, Victoria, BC, V8W 3P6, Canadae-mail: curranc@uvic.ca
Jim Platts
Institute for Manufacturing, Department of Engineering,
Cambridge University
, Mill Lane, Cambridge, CB2 1RX, UKe-mail: mjp@eng.cam.ac.uk
J. Sol. Energy Eng. Aug 2008, 130(3): 031002 (8 pages)
Published Online: June 13, 2008
Article history
Received:
March 9, 2006
Revised:
September 5, 2006
Published:
June 13, 2008
Citation
Crawford, C., and Platts, J. (June 13, 2008). "Updating and Optimization of a Coning Rotor Concept." ASME. J. Sol. Energy Eng. August 2008; 130(3): 031002. https://doi.org/10.1115/1.2931497
Download citation file:
Get Email Alerts
Analysis of Erosion of Surfaces in Falling Particle Concentrating Solar Power
J. Sol. Energy Eng (April 2025)
Related Articles
A Parallelized Coupled Navier-Stokes/Vortex-Panel Solver
J. Sol. Energy Eng (November,2005)
3D Woven Carbon/Glass Hybrid Spar Cap for Wind Turbine Rotor Blade
J. Sol. Energy Eng (November,2006)
Optimization of Wind Turbines Using Helicoidal Vortex Model
J. Sol. Energy Eng (November,2003)
The Performance of Wind Turbine Smart Rotor Control Approaches During Extreme Loads
J. Sol. Energy Eng (February,2010)
Related Proceedings Papers
Related Chapters
Wind Turbine Airfoils and Rotor Wakes
Wind Turbine Technology: Fundamental Concepts in Wind Turbine Engineering, Second Edition
Unbalance
Fundamentals of Rotating Machinery Diagnostics
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential