An experimental study was conducted to investigate the effect of electronic flow control on the performance of a variable-speed heat pump. A heat pump with two different expansion devices (capillary tube and electronic expansion valve) was tested in a psychrometric calorimeter over a range of outdoor temperatures from −15 to 7°C. Heat pump performance was first optimized with respect to charge for each expansion device through cycle-matching tests. Parametric tests also were conducted by changing compressor speed and opening angle for the electronic expansion valve at each outdoor temperature. The refrigeration cycle characteristics of the electronic valve were illustrated using pressure-enthalpy diagrams. Performance enhancement was also analyzed in terms of superheat, heating capacity, and energy efficiency ratio (EER). Comparison of the capillary tube and electronic valve indicated that the superheat significantly improved when using the electronic valve. Also, unit showed larger heating capacity and EER with the electronic valve than with the capillary tube except when the compressor speed was above 95 Hz. Enhancement of heating performance became larger as outdoor temperature decreased.
Skip Nav Destination
Article navigation
Article
Effect of Refrigerant Flow Control on the Heating Performance of a Variable-Speed Heat Pump Operating at Low Outdoor Temperature
Bong H. Kim,
Bong H. Kim
Automotive, Industrial, and Mechanical Engineering Department, Daegu University, Korea
Search for other works by this author on:
Dennis L. O’Neal
Dennis L. O’Neal
Mechanical Engineering Department, Texas A&M University, College Station, TX 77843
Search for other works by this author on:
Bong H. Kim
Automotive, Industrial, and Mechanical Engineering Department, Daegu University, Korea
Dennis L. O’Neal
Mechanical Engineering Department, Texas A&M University, College Station, TX 77843
Contributed by the Solar Energy Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS Manuscript received by the ASME Solar Energy Division April 7, 2004; final revision July 19, 2004. Associate Editor: V. C. Mei.
J. Sol. Energy Eng. May 2005, 127(2): 277-286 (10 pages)
Published Online: April 25, 2005
Article history
Received:
April 7, 2004
Revised:
July 19, 2004
Online:
April 25, 2005
Citation
Kim, B. H., and O’Neal, D. L. (April 25, 2005). "Effect of Refrigerant Flow Control on the Heating Performance of a Variable-Speed Heat Pump Operating at Low Outdoor Temperature ." ASME. J. Sol. Energy Eng. May 2005; 127(2): 277–286. https://doi.org/10.1115/1.1849224
Download citation file:
Get Email Alerts
Cited By
Numerical Investigations on Minimization of Convective Heat Losses From Hemispherical Cavity Receiver Using Air Curtain
J. Sol. Energy Eng (June 2025)
Related Articles
Modeling of Surge Characteristics in Turbo Heat Pumps
J. Turbomach (October,2011)
Computational Modeling and Analysis of Multiple Steady States in Vapor Compression Systems
J. Comput. Nonlinear Dynam (April,2007)
Centrifugal Compressor Surge in Closed-Loop Systems: Initial Modeling and Comparison With Experiments
J. Eng. Gas Turbines Power (March,2025)
Studies of Heat Pumps Using Direct Expansion Type Solar Collectors
J. Sol. Energy Eng (February,2005)
Related Proceedings Papers
Related Chapters
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Dynamic Behavior of Pumping Systems
Pipeline Pumping and Compression Systems: A Practical Approach
A Study on the Refrigerant Charge Quantity of Ground Source Heat Pump System
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)