The influence of turbulence conditions on the design loads for wind turbines is investigated by using inverse reliability techniques. Alternative modeling assumptions for randomness in the gross wind environment and in the extreme response given wind conditions to establish nominal design loads are studied. Accuracy in design load predictions based on use of the inverse first-order reliability method (that assumes a linearized limit state surface) is also investigated. An example is presented where three alternative nominal load definitions are used to estimate extreme flapwise bending loads at a blade root for a 600 kW three-bladed, stall-regulated horizontal-axis wind turbine located at onshore and offshore sites that were assumed to experience the same mean wind speed but different turbulence intensities. It is found that second-order (curvature-type) corrections to the linearized limit state function assumption inherent in the inverse first-order reliability approach are insignificant. Thus, we suggest that the inverse first-order reliability method is an efficient and accurate technique of predicting extreme loads. Design loads derived from a full random characterization of wind conditions as well as short-term maximum response (given wind conditions) may be approximated reasonably well by simpler models that include only the randomness in the wind environment but account for response variability by employing appropriately derived “higher-than-median” fractiles of the extreme bending loads conditional on specified inflow parameters. In the various results discussed, it is found that the higher relative turbulence at the onshore site leads to larger blade bending design loads there than at the offshore site. Also, for both onshore and offshore environments accounting for response variability is found to be slightly more important at longer return periods (i.e., safer designs).
Skip Nav Destination
Article navigation
November 2004
Technical Papers
A Comparison of Wind Turbine Design Loads in Different Environments Using Inverse Reliability Techniques
Korn Saranyasoontorn,
Korn Saranyasoontorn
Department of Civil Engineering, University of Texas at Austin, Austin, TX 78712
Search for other works by this author on:
Lance Manuel
Lance Manuel
Department of Civil Engineering, University of Texas at Austin, Austin, TX 78712
Search for other works by this author on:
Korn Saranyasoontorn
Department of Civil Engineering, University of Texas at Austin, Austin, TX 78712
Lance Manuel
Department of Civil Engineering, University of Texas at Austin, Austin, TX 78712
Contributed by the Solar Energy Division of The American Society of Mechanical Engineers for publication in the ASME JOURNAL OF SOLAR ENERGY ENGINEERING. Manuscript received by the ASME Solar Division; January 16, 2004; final revision May 10, 2004. Associat Editor: P. Chaviaropoulous.
J. Sol. Energy Eng. Nov 2004, 126(4): 1060-1068 (9 pages)
Published Online: November 18, 2004
Article history
Online:
November 18, 2004
Citation
Saranyasoontorn , K., and Manuel, L. (November 18, 2004). "A Comparison of Wind Turbine Design Loads in Different Environments Using Inverse Reliability Techniques ." ASME. J. Sol. Energy Eng. November 2004; 126(4): 1060–1068. https://doi.org/10.1115/1.1796971
Download citation file:
Get Email Alerts
Analysis of Erosion of Surfaces in Falling Particle Concentrating Solar Power
J. Sol. Energy Eng (April 2025)
Related Articles
Guest Editorial
J. Sol. Energy Eng (August,2008)
The Greek Center for Renewable Energy Sources (CRES) 3 MW Demonstration Wind Farm
J. Sol. Energy Eng (November,2004)
Modern Wind Power Plant in Minnesota
J. Sol. Energy Eng (August,2001)
A Message from the Special Issue Editor
J. Sol. Energy Eng (November,2001)
Related Proceedings Papers
Related Chapters
A Utility Perspective of Wind Energy
Wind Turbine Technology: Fundamental Concepts in Wind Turbine Engineering, Second Edition
Power Quality Improvement in Windmill System Using STATCOM
International Conference on Computer Technology and Development, 3rd (ICCTD 2011)
Analysis of Failure and Reliability for Constant Speed and Constant Pitch Wind Turbine
International Conference on Software Technology and Engineering, 3rd (ICSTE 2011)