The optimal design of stationary photovoltaic and thermal collectors in a solar field, taking into account shading and masking effects, may be based on several criteria: maximum incident energy on collector plane from a given field, minimum field area for given incident energy, minimum cost per unit energy, minimum plant cost, maximum energy per unit collector area or other objectives. These design problems may be formulated as optimization problems with objective functions and sets of constraints (equality and inequality) for which mathematical optimization techniques may be applied. This article deals with obtaining the field design parameters (optimal number of rows, distance between collector rows, collector height and collector inclination angle) that produce maximum annual energy from a given field. A second problem is determination of the minimum field area (length and width) and field design parameters that produce a given required annual energy. The third problem is determination of the optimal field design parameters for obtaining maximum energy per unit collector area from a given field. The results of these optimal designs are compared to a recommended approach of the Israeli Institute of Standards (IIS) in which the solar field design result in negligible shading. An increase in energy of about 20% for a fixed field area and a decrease in field area of about 15% for a given annual incident energy, respectively, may be obtained using the approach formulated in the present article compared to the IIS approach.
Skip Nav Destination
e-mail: [email protected]
Article navigation
August 2004
Technical Papers
Optimal Solar Field Design of Stationary Collectors Available to Purchase
Dan Weinstock, Ph.D. student,
e-mail: [email protected]
Dan Weinstock, Ph.D. student
Faculty of Engineering, Tel-Aviv University, Tel-Aviv, 69978, Israel, 972-3-6409014
Search for other works by this author on:
Joseph Appelbaum
Joseph Appelbaum
Faculty of Engineering, Tel-Aviv University, Tel-Aviv, 69978, Israel, 972-3-6409014
Search for other works by this author on:
Dan Weinstock, Ph.D. student
Faculty of Engineering, Tel-Aviv University, Tel-Aviv, 69978, Israel, 972-3-6409014
e-mail: [email protected]
Joseph Appelbaum
Faculty of Engineering, Tel-Aviv University, Tel-Aviv, 69978, Israel, 972-3-6409014
Contributed by the Solar Energy Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF SOLAR ENERGY ENGINEERING. Manuscript received by the ASME Solar Division August 2003; final revision April 2004. Associate Editor: A. Kribus.
J. Sol. Energy Eng. Aug 2004, 126(3): 898-905 (8 pages)
Published Online: July 19, 2004
Article history
Received:
August 1, 2003
Revised:
April 1, 2004
Online:
July 19, 2004
Citation
Weinstock, D., and Appelbaum, J. (July 19, 2004). "Optimal Solar Field Design of Stationary Collectors ." ASME. J. Sol. Energy Eng. August 2004; 126(3): 898–905. https://doi.org/10.1115/1.1756137
Download citation file:
Get Email Alerts
SOLAR DRYING OF RED PEPPER: THERMODYNAMIC AND EXPERIMENTAL STUDY
J. Sol. Energy Eng
Design and Principle of Novel Linear Solar Concentrator With Asymmetric Parabolic Reflector and Independently Movable Receiver
J. Sol. Energy Eng (December 2025)
Determining Diffuse Solar Irradiance: A Comparison of Single and Multiparameter Separation Models for Nepal
J. Sol. Energy Eng (October 2025)
Related Articles
Optimization of Solar Photovoltaic Fields
J. Sol. Energy Eng (August,2009)
Passive Cooling Strategies in Summer for Office Buildings in Temperate Clear Sky Climates: Assessment of Effectiveness With Zero-Energy Building Criteria
J. Eng. Sustain. Bldgs. Cities (November,2023)
Optimization of Economic Solar Field Design of Stationary Thermal Collectors
J. Sol. Energy Eng (November,2007)
Multi-Objective Optimal Design of Stationary Flat-Plate Solar Collectors Under Probabilistic Uncertainty
J. Mech. Des (September,2010)
Related Proceedings Papers
Related Chapters
Topology Optimization to Design of Connecting Rod
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3
Optimization Program of Company's Supplier Management System Based on SF
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3
Advances on the Constitutive Characterization of Composites via Multiaxial Robotic Testing and Design Optimization
Advances in Computers and Information in Engineering Research, Volume 1