Polymers offer a lightweight, low cost option for solar hot water system components. Key to the success of polymer heat exchanger components will be the long term mechanical performance of the polymer. This is particularly true for heat exchangers in which one of the fluids is pressurized hot water. For domestic hot water systems, polymer components must not fail after many years at a constant pressure (stress levels selected to correspond to 0.55 MPa in a tube) when immersed in 82°C potable water. In this paper, the long term performance of two potential heat exchanger materials, polybutylene and nylon 6,6, is presented. Two failure mechanisms are considered: failure caused by material rupture (as indicated by the hydrostatic burst strength) and failure caused by excessive deformation (as indicated by the creep modulus). Hydrostatic burst strength and creep modulus data are presented for each material. Master curves for the creep compliance as a function of time are derived from experimental data. These master curves provide a mechanism for predicting creep modulus as a function of time. A case study is presented in which tubing geometry is selected given the hydrostatic burst strength and creep compliance data. This approach can be used to evaluate properties of candidate polymers and to design polymer components for solar hot water applications.

Issue Section:
Technical Papers
Keywords:
solar heating, heat exchangers, failure (mechanical), deformation, mechanical strength, creep fracture, polymers
Topics:
Creep, Failure, Hot water, Nylon fabrics, Polymers, Solar energy, Stress, Temperature, Tubing, Water, Testing, Pressure
1.
Davidson, J. H., Mantell, S. C., Kulacki, F. A., Liu, W., and Wu, C., 2002, “Mechanical and Thermal Performance of Polymer Heat Exchangers for Solar Hot Water,” International Conference on Heat Transfer, Grenoble, France.
2.
Liu, W., Davidson, J., Kulacki, F., and Mantell, S. C., 2002, “Natural Convection of a Horizontal Tube Heat Exchanger Immersed in a Tilted Enclosure,” Solar 2002, the 2002 American Solar Energy Conference, Reno, NV.
3.
Raman
,
R.
,
Mantell
,
S. C.
,
Davidson
,
J. H.
,
Wu
,
C.
, and
Jorgensen
,
G.
,
2000
, “
A Review of Polymer Materials for Solar Water Heating Systems
,”
J. Sol. Energy Eng.
,
122
, pp.
92
–
100
.
4.
ASTM, 2000, Standard D2837: Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials, American Society of Testing and Materials, Philadelphia, PA.
5.
PPI, 2000, “Hydrostatic Design Bases and Maximum Recommended Hydrostatic Design Stresses for Thermoplastic Piping Materials,” Report #TR-4, Plastic Pipe Institute, Washington D. C.
6.
Schapery
,
R. A.
,
1969
, “
On the Characterization of Nonlinear Viscoelastic Materials
,”
Polym. Eng. Sci.
,
9
(
4
), pp.
294
–
310
.
7.
ASTM, 1996, Standard D2581: Standard Specification for Polybutylene (PB) Plastics Molding and Extrusion Materials, American Society of Testing and Materials, Philadelphia, PA.
8.
ASTM, 1996, Standard D4066: Standard Specification for Nylon Injection and Extrusion Materials, American Society of Testing and Materials, Philadelphia, PA.
Copyright © 2004
 by ASME
You do not currently have access to this content.