In modern wind turbine blades, airfoils of more than 25% thickness can be found at mid-span and inboard locations. At mid-span, aerodynamic requirements dominate, demanding a high lift-to-drag ratio, moderate to high lift and low roughness sensitivity. Towards the root, structural requirements become more important. In this paper, the performance for the airfoil series DU FFA, S8xx, AH, Risø and NACA are reviewed. For the 25% and 30% thick airfoils, the best performing airfoils can be recognized by a restricted upper-surface thickness and an S-shaped lower surface for aft-loading. Differences in performance of the DU 91-W2-250 (25%), S814 (24%) and Risø-A1-24 (24%) airfoils are small. For a 30% thickness, the DU 97-W-300 meets the requirements best. Reduction of roughness sensitivity can be achieved both by proper design and by application of vortex generators on the upper surface of the airfoil. Maximum lift and lift-to-drag ratio are, in general, enhanced for the rough configuration when vortex generators are used. At inboard locations, 2-D wind tunnel tests do not represent the performance characteristics well because the influence of rotation is not included. The RFOIL code is believed to be capable of approximating the rotational effect. Results from this code indicate that rotational effects dramatically reduce roughness sensitivity effects at inboard locations. In particular, the change in lift characteristics in the case of leading edge roughness for the 35% and 40% thick DU airfoils, DU 00-W-350 and DU 00-W-401, respectively, is remarkable. As a result of the strong reduction of roughness sensitivity, the design for inboard airfoils can primarily focus on high lift and structural demands.
Skip Nav Destination
e-mail: R.vanRooij@citg.tudelft.nl
e-mail: W.A.Timmer@citg.tudelft.nl
Article navigation
November 2003
Technical Papers
Roughness Sensitivity Considerations for Thick Rotor Blade Airfoils
R. P. J. O. M. van Rooij,
e-mail: R.vanRooij@citg.tudelft.nl
R. P. J. O. M. van Rooij
Delft University Wind Energy Research Institute, Faculty of Civil Engineering and Geosciences, Stevinweg 1, 2628CN, Delft, the Netherlands
Search for other works by this author on:
W. A. Timmer
e-mail: W.A.Timmer@citg.tudelft.nl
W. A. Timmer
Delft University Wind Energy Research Institute, Faculty of Civil Engineering and Geosciences, Stevinweg 1, 2628CN, Delft, the Netherlands
Search for other works by this author on:
R. P. J. O. M. van Rooij
Delft University Wind Energy Research Institute, Faculty of Civil Engineering and Geosciences, Stevinweg 1, 2628CN, Delft, the Netherlands
e-mail: R.vanRooij@citg.tudelft.nl
W. A. Timmer
Delft University Wind Energy Research Institute, Faculty of Civil Engineering and Geosciences, Stevinweg 1, 2628CN, Delft, the Netherlands
e-mail: W.A.Timmer@citg.tudelft.nl
Contributed by the Solar Energy Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF SOLAR ENERGY ENGINEERING. Manuscript received by the ASME Solar Energy Division January 24, 2003; final revision, July 12, 2003. Associate Editor: D. Berg.
J. Sol. Energy Eng. Nov 2003, 125(4): 468-478 (11 pages)
Published Online: November 26, 2003
Article history
Received:
January 24, 2003
Revised:
July 12, 2003
Online:
November 26, 2003
Citation
van Rooij, R. P. J. O. M., and Timmer, W. A. (November 26, 2003). "Roughness Sensitivity Considerations for Thick Rotor Blade Airfoils ." ASME. J. Sol. Energy Eng. November 2003; 125(4): 468–478. https://doi.org/10.1115/1.1624614
Download citation file:
Get Email Alerts
Analysis of Erosion of Surfaces in Falling Particle Concentrating Solar Power
J. Sol. Energy Eng (April 2025)
Related Articles
Peak and Post-Peak Power Aerodynamics from Phase VI NASA Ames Wind Turbine Data
J. Sol. Energy Eng (May,2005)
Active Load Control for Airfoils using Microtabs
J. Sol. Energy Eng (November,2001)
Blade-Wake Interaction Noise for Turbines With Downwind Rotors
J. Sol. Energy Eng (November,2003)
Design and Verification of the Risø-B1 Airfoil Family for Wind Turbines
J. Sol. Energy Eng (November,2004)
Related Proceedings Papers
Related Chapters
Other Components and Variations
Axial-Flow Compressors
Wind Turbine Airfoils and Rotor Wakes
Wind Turbine Technology: Fundamental Concepts in Wind Turbine Engineering, Second Edition
Wind Turbine Aerodynamics Part A: Basic Principles
Wind Turbine Technology: Fundamental Concepts in Wind Turbine Engineering, Second Edition