This paper examines the operating modes of a two-bladed wind turbine structural model. Because of the gyroscopic asymmetry of its rotor, this turbine’s dynamics can be quite distinct from that of a turbine with three or more blades. This asymmetry leads to system equations with periodic coefficients that must be solved by the Floquet approach to extract the correct modal parameters. A discussion of results is presented for a series of simple models with increasing complexity. We begin with a single-degree-of-freedom system and progress to a model with seven degrees-of-freedom: tower fore-aft bending, tower lateral bending, tower twist, nacelle yaw, hub teeter, and flapwise bending of each blade. Results illustrate how the turbine modes become more dominated by the centrifugal and gyroscopic effects as the rotor speed increases. Parametric studies are performed by varying precone angle, teeter stiffness, yaw stiffness, teeter damping, and yaw damping properties. Under certain levels of yaw stiffness or damping, the gyroscopic coupling may cause yaw and teeter mode coalescence, resulting in self-excited dynamic instabilities. Teeter damping is the only parameter found to strictly stabilize the turbine model.
Skip Nav Destination
Article navigation
November 2002
Technical Papers
Floquet Modal Analysis of a Teetered-Rotor Wind Turbine
Karl Stol,
Karl Stol
National Renewable Energy Laboratory, National Wind Technology Center, 1617 Cole Blvd., Golden, CO 80401-3393
Search for other works by this author on:
Mark Balas,
Mark Balas
Department of Aerospace Engineering Science, University of Colorado at Boulder, Boulder, CO 80309-0429
Search for other works by this author on:
Gunjit Bir
Gunjit Bir
National Renewable Energy Laboratory, National Wind Technology Center, 1617 Cole Blvd., Golden, CO 80401-3393
Search for other works by this author on:
Karl Stol
National Renewable Energy Laboratory, National Wind Technology Center, 1617 Cole Blvd., Golden, CO 80401-3393
Mark Balas
Department of Aerospace Engineering Science, University of Colorado at Boulder, Boulder, CO 80309-0429
Gunjit Bir
National Renewable Energy Laboratory, National Wind Technology Center, 1617 Cole Blvd., Golden, CO 80401-3393
Contributed by the Solar Energy Division of the American Society of Mechanical Engineers for publication in the ASME JOURNAL OF SOLAR ENERGY ENGINEERING. Manuscript received by the ASME Solar Energy Division, May 2001, final revision, March 2002. Associate Editor: D. Berg.
J. Sol. Energy Eng. Nov 2002, 124(4): 364-371 (8 pages)
Published Online: November 8, 2002
Article history
Received:
May 1, 2001
Revised:
March 1, 2002
Online:
November 8, 2002
Citation
Stol, K., Balas, M., and Bir, G. (November 8, 2002). "Floquet Modal Analysis of a Teetered-Rotor Wind Turbine ." ASME. J. Sol. Energy Eng. November 2002; 124(4): 364–371. https://doi.org/10.1115/1.1504846
Download citation file:
Get Email Alerts
Related Articles
Design of Controls to Attenuate Loads in the Controls Advanced Research Turbine
J. Sol. Energy Eng (November,2004)
U.S. National Laboratory Research Supporting Low Wind Speed Technology
J. Sol. Energy Eng (November,2002)
Testing State-Space Controls for the Controls Advanced Research Turbine
J. Sol. Energy Eng (November,2006)
Design of State-Space-Based Control Algorithms for Wind Turbine Speed Regulation
J. Sol. Energy Eng (November,2003)
Related Proceedings Papers
Related Chapters
Summary and Conclusions
Bearing Dynamic Coefficients in Rotordynamics: Computation Methods and Practical Applications
Wind Turbine Airfoils and Rotor Wakes
Wind Turbine Technology: Fundamental Concepts in Wind Turbine Engineering, Second Edition
Three-Dimensional Solid Modeling of Large Wind Turbine Blade Based on Wilson Theory
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)