Accurate modeling of hourly heating and cooling energy use in commercial buildings can be achieved by a Generalized Fourier Series (GFS) approach involving weather variables such as dry-bulb temperature, specific humidity and horizontal solar flux. However, there are situations when only temperature data is available. The objective of this paper is to (i) describe development of a variant of the GFS approach which allows modeling both heating and cooling hourly energy use in commercial buildings with outdoor temperature as the only weather variable and (ii) illustrate its application with monitored hourly data from several buildings in Texas. It is found that the new Temperature based Fourier Series (TFS) approach (i) provides better approximation to heating energy use than the existing GFS approach, ((ii) can indirectly account for humidity and solar effects in the cooling energy use, (iii) offers physical insight into the operating pattern of a building HVAC system and (iv) can be used for diagnostic purposes.

Issue Section:
Research Papers
Topics:
Energy consumption, Fourier series, Heating and cooling, Structures, Temperature, Modeling, Solar energy, Approximation, Cooling, Heating, HVAC equipment
1.
Claridge, D., Haberl, J., Turner, W., O’Neal, D., Heffington, W., Tombari, C., and Jeager, S., 1991, “Improving Energy Conservation Retrofits with Measured Savings,” ASHRAE Journal, October, pp. 14–22.
2.
Dhar, A., Reddy, T. A., and Claridge, D. E., 1994a, “Improved Fourier Series Approach to Modeling Hourly Energy Use in Commercial Buildings,” Proceedings of the ASME/JSME/JSES Solar Energy Conference, pp. 455–468, San Francisco, March,
3.
Dhar, A., Reddy, T. A., and Claridge, D.E., 1994b , “Generalization of the Fourier Series Approach to Model Hourly Energy Use in Commercial Buildings,” accepted for publication in ASME JOURNAL OF SOLAR ENERGY ENGINEERING.
4.
Fels, M., 1986, Special Issue Devoted to “Measured Energy Savings, The Princeton Score Keeping Method (PRISM),” Energy and Buildings, Vol. 9, Nos. 1 and 2.
5.
Katipamula
S.
, and
Claridge
D. E.
,
1993
, “
Use of Simplified Systems Models to Measure Retrofit Savings
,”
ASME JOURNAL OF SOLAR ENERGY ENGINEERING
, Vol.
115
, pp.
57
–
68
.
6.
Katipamula, S., Reddy, T. A., and Claridge, D. E., 1994, “Development and Application of Regression Models to Predict Cooling Energy Consumption in Large Commercial Buildings,” Proceedings of the ASME/JSME/JSES Solar Energy Conference, pp. 307–322, San Francisco, March.
7.
Kissock, J. K., 1993, “A Methodology to Measure Retrofit Energy Savings in Commercial Buildings,” Ph.D. Dissertation, Mechanical Engineering Department, Texas A&M University, Texas, December.
8.
Kreider
J.
, and
Wang
X.
,
1991
, “
Artificial Neural Networks Demonstrated for Automated Generation of Energy Use Predictors for Commercial Buildings
,”
ASHRAE Transactions
, Vol.
97
, pp.
775
–
779
.
9.
Ott, L., 1988, An Introduction to Statistical Methods and Data Analysis, PWS-KENT Publishing Company, Boston.
10.
Reddy, T. A., Katipamula, S., and Claridge, D, E., 1994, “The Functional Basis of Thermal Energy Use in Air-side HVAC Equipment,” accepted for publication by the ASME JOURNAL OF SOLAR ENERGY ENGINEERING.
11.
Ruch
D.
, and
Claridge
D. E.
,
1992
, “
A Four-Parameter Change Point Model for Predicting Energy Consumption in Commercial Buildings
,”
ASME JOURNAL OF SOLAR ENERGY ENGINEERING
, Vol.
114
, pp.
77
–
83
.
This content is only available via PDF.
You do not currently have access to this content.