This brief deals with crack(s) emanating from a hole in infinite plate subjected to uniform internal pressure. Such a crack problem is called a hole crack problem for short. By using a hybrid displacement discontinuity method (a boundary element method) proposed recently by Yan, three hole crack problems (an elliptical hole crack problem, a rhombus hole crack problem, and a triangle hole crack problem) in infinite plate subjected to uniform internal pressure are analyzed in detail. By changing hole geometry form and hole geometry parameters and by comparing the stress intensity factors (SIFs) of the hole crack problem with those of the center crack problem, the effect of the hole geometry form and hole geometry parameters on the SIFs is revealed. It is found that a hole has a shielding and an amplifying effect on the SIFs of crack(s) emanating from the hole. The shielding and amplifying effects are varied with hole geometry form and hole geometry parameters.
Skip Nav Destination
Article navigation
December 2011
Technical Briefs
Hole Crack Problems in Infinite Plate Subjected to Uniform Internal Pressure
Xiangqiao Yan,
Xiangqiao Yan
Research Laboratory on Composite Materials, Harbin Institute of Technology
, Harbin 150001, P. R. China
Search for other works by this author on:
Baoliang Liu
Baoliang Liu
Research Laboratory on Composite Materials, Harbin Institute of Technology
, Harbin 150001, P. R. China
Search for other works by this author on:
Xiangqiao Yan
Research Laboratory on Composite Materials, Harbin Institute of Technology
, Harbin 150001, P. R. China
Baoliang Liu
Research Laboratory on Composite Materials, Harbin Institute of Technology
, Harbin 150001, P. R. China
J. Pressure Vessel Technol. Dec 2011, 133(6): 064502 (5 pages)
Published Online: October 3, 2011
Article history
Received:
October 15, 2010
Revised:
March 23, 2011
Online:
October 3, 2011
Published:
October 3, 2011
Citation
Yan, X., and Liu, B. (October 3, 2011). "Hole Crack Problems in Infinite Plate Subjected to Uniform Internal Pressure." ASME. J. Pressure Vessel Technol. December 2011; 133(6): 064502. https://doi.org/10.1115/1.4003954
Download citation file:
92
Views
Get Email Alerts
Cited By
Measurement of Steam-Generator-Tube Vibration Damping Caused by Anti-Vibration-Bar Supports
J. Pressure Vessel Technol (February 2025)
Surface Strain Measurement for Non-Intrusive Internal Pressure Evaluation of a Cannon
J. Pressure Vessel Technol (December 2024)
Dynamic Response and Damage Analysis of a Large Steel Tank Impacted by an Explosive Fragment
J. Pressure Vessel Technol (February 2025)
Related Articles
Numerical Simulation of Delamination in IC Packages Using a New Variable-Order Singular Boundary Element
J. Electron. Packag (December,2003)
Failure Assessment on Tensile Cracked Specimens of Aluminum Alloys
J. Pressure Vessel Technol (August,2004)
A Complex Potential-Variational Method for Stress Analysis of Unsymmetric Laminates With an Elliptical Cutout
J. Appl. Mech (September,2001)
3-D Stress Intensity Factors for Internal Cracks in an Overstrained Cylindrical Pressure Vessel—Part II: The Combined Effect of Pressure and Autofrettage
J. Pressure Vessel Technol (February,2001)
Related Proceedings Papers
Related Chapters
Section VIII: Division 2–Alternative Rules
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 2, Sixth Edition
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design
Introductory Information
The Stress Analysis of Cracks Handbook, Third Edition