The high-pressure hydrogenation cracking unit is the core equipment system in the aromatic hydrocarbon factory, which is subjected simultaneously to the action of hydrogen, high pressure, and high temperature. In this paper, quantitative analysis method of risk-based inspection (RBI) was carried out with a commercially available RBI software. In API 581, the risk situation for each type of equipment in the system was classified into four grades: low-risk grade, medium-risk grade, medium-high-risk grade, and high grade. This is expressed as a risk matrix. The entire risk distribution of 553 equipment and/or piping items of the systems that compose the unit was obtained. The hydrocracking reactors and the reactor effluent air coolers are in the “medium-high-risk” category. Based on the RBI results, an optimum inspection plan was developed by the author to reduce the risk level for the hydrogenation cracking unit. Upon validation of the inspection activity in 2004, it is concluded that the optimum inspection plan was in compliance with the engineering specification of the aromatic hydrocarbon factory.

1.
2003,
The ASME High Pressure System Standard
,
American Society of Mechanical Engineers
,
New York
.
2.
Brown
,
S. J.
, 2006, “
Historical Development of a Standard to Reduce Risk From Pressure Systems Failure—Part I: The ASME HPS Section 6000
.”
ASME J. Pressure Vessel Technol.
0094-9930,
128
, pp.
109
115
.
3.
Brown
,
S. J.
, 2006, “
Historical Development of a Standard to Reduce Risk From Pressure Systems Failure—Part II: The ASME HPS-2003 Section 6000 “Hazardous Release Protection”
,”
ASME J. Pressure Vessel Technol.
0094-9930,
128
, pp.
116
121
.
4.
2000, API 581, Risk-Based Inspection-Base Resource Document,
American Petroleum Institute
, Washington, DC.
5.
2002, API, 580, Risk-Based Inspection-Recommended Practice,
American Petroleum Institute
, Washington, DC.
6.
Wang
,
J. X.
, and
Roush
,
M. L.
, 2000,
What Every Engineer Should Know About: Risk Engineering and Management
,
Dekker
,
New York
.
7.
Reynolds
,
J. T.
, 1996, “
The Application of Risk-Based Inspection Methodology in the Petroleum and Petrochemical Industry
,”
Structural Integrity, NDE, Risk and Material Performance for Petroleum, Process and Power
, PVP-Vol.
336
,
American Society of Mechanical Engineers
,
New York
.
8.
1991, CRTD-20-1, Risk-Based Inspection-Development of Guidelines, Vol.
1
, General Document,
American Society of Mechanical Engineers
, New York.
9.
ORBIT-ONSHORE RBI Software, Det Norske Veritas (DNV), 2003, Norway.
10.
Microsoft Excel Workspace Sheet of RBI Analysis, Det Norske Veritas (DNV), 2003, Norway.
11.
Lee
,
S.-M.
,
Chang
,
Y.-S.
,
Choi
,
J.-B.
, and
Kim
,
Y.-J.
, 2006, “
Application of an Enhanced RBI Method for Petrochemical Equipments
,”
ASME J. Pressure Vessel Technol.
0094-9930,
128
, pp.
445
453
.
You do not currently have access to this content.