A 155 mm compound gun barrel with full-length integral mid-wall cooling channels was manufactured and connected to a purpose built heat exchanger. Laboratory testing of this system was carried out using electrical heating jackets applied to the outer surface of the barrel and an internal electrical chamber heater to heat the barrel as uniformly as possible along its length. A series of tests were then carried out consisting of first heating the barrel to a uniform temperature of approximately 80°C followed by switching on the heat exchanger and monitoring the rate at which the barrel cooled. The purpose of these tests was to determine the optimum cooling characteristics of the system by studying the effect of different coolant flow rates combined with one or both radiators functioning and also the effect of using different cooling fluid solutions. Having derived the optimum flow rate and coolant solution combination a further cooling test was carried out with the heat exchanger configured to these optimum values and with the barrel heaters operating at maximum capacity. Finally a natural cooling test was undertaken where the barrel was uniformly heated to 160°C, the heating jackets removed and the barrel left to cool overnight. The results from these tests prove that natural cooling is dramatically slower than forced mid-wall cooling.
Skip Nav Destination
Article navigation
Research Papers
Laboratory Heat Transfer Experiments on a Compound Gun Tube With Full Length Integral Mid-Wall Cooling Channels
Rolf R. de Swardt
Rolf R. de Swardt
Search for other works by this author on:
Mark Bass
Rolf R. de Swardt
J. Pressure Vessel Technol. May 2006, 128(2): 279-284 (6 pages)
Published Online: January 17, 2006
Article history
Received:
December 22, 2005
Revised:
January 17, 2006
Citation
Bass, M., and de Swardt, R. R. (January 17, 2006). "Laboratory Heat Transfer Experiments on a Compound Gun Tube With Full Length Integral Mid-Wall Cooling Channels." ASME. J. Pressure Vessel Technol. May 2006; 128(2): 279–284. https://doi.org/10.1115/1.2179434
Download citation file:
Get Email Alerts
Cited By
Surface Strain Measurement for Non-Intrusive Internal Pressure Evaluation of a Cannon
J. Pressure Vessel Technol (December 2024)
Dynamic Response and Damage Analysis of a Large Steel Tank Impacted by an Explosive Fragment
J. Pressure Vessel Technol (February 2025)
Related Articles
Theoretical and Experimental Study of a Flexible Wiretype Joule–Thomson Microrefrigerator for Use in Cryosurgery
J. Heat Transfer (February,2012)
Heat Transfer of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger Geometries
J. Thermal Sci. Eng. Appl (September,2011)
Efficiency Improvement of Photovoltaic Solar Modules by Cooling Using an Underground Heat Exchanger
J. Sol. Energy Eng (December,2022)
A Novel Way to Control Wall Temperature Distribution by Grading Blowing Rate
J. Heat Mass Transfer (March,2023)
Related Proceedings Papers
Related Chapters
Personnel and Requirements
Heat Exchanger Engineering Techniques
Characteristics, Components, and Performance of A/C System Exchangers
Heat Exchanger Engineering Techniques
The Cause of Most Field Problems
Heat Exchanger Engineering Techniques