1.
Becker, K. M., and Kaye, J., 1962, “The Influence of a Radial Temperature Gradient on the Instability of Fluid Flow in an Annulus with Inner Rotating Cylinder,” ASME Journal of Heat Transfer, May, pp. 106–110.
2.
Featherstone, P. F., et al., 1973, “Thermal Behavior of Turbine Casings in High Output Generating Plant,” I. Mech. E., U.K. Conference Publication, C189/73.
3.
Gardon
R.
,
1960
, “
A Transdcer for Measurement of Heat Flow Rate
,”
ASME Journal of Heat Transfer
, Vol.
82
, pp.
396
398
.
4.
Gazley
C.
,
1958
, “
Heat Transfer Characteristics of the Rotational and Axial Flow Between Concentric Cylinders
,”
TRANS, ASME
, Vol.
80
(
1
), pp.
79
90
.
5.
Kays
W. M.
, and
Leung
E. Y.
,
1963
, “
Heat Transfer in Annular Passages—Hydrodynamically Developed Turbulent Flow With Arbitrarily Prescribed Heat Flux
,”
International Journal of Heat and Mass Transfer
, Vol.
6
, pp.
537
557
.
6.
Luke
G. E.
,
1926
, “
Surface Heat Transfer in Electrical Machines With Forced Air Flow
,”
Trans. AIEE
, Vol.
XLV
, pp.
1036
1047
.
7.
Molozhen
L. M. Z.
, and
Polyak
A. P.
,
1970
, “
Heat Transfer in Annulus Between Stationary and Rotating Co-axial Cylinders
,”
Teploenergetika
, Vol.
17
(
6
), pp.
46
50
.
8.
Plotkin
E. R.
,
Leizerovich
A. Sh.
, and
Muratova
I. V.
,
1971
, “
Investigation of Heat Transfer Conditions in the K-200-130 Turbine
,”
Thermal Engineering
, Vol.
18
(
5
), pp.
41
47
.
9.
Swanson Analysis Systems, 1989, ANSYS Users Manual, Ver. 4.4.
10.
Tachibana
F.
, and
Fukui
S.
,
1964
, “
Convective Heat Transfer of the Rotational and Axial Flow between Two Concentric Cylinders
,”
Bulletin JSME
, Vol.
7
(
26
), pp.
385
391
.
11.
Tret’yakov
T. G.
,
1971
, “
Determination of the Coefficient of Heat Transfer in Turbines from Measurements Data
,”
Teploenergetika
, Vol.
18
(
5
), pp.
27
31
.
This content is only available via PDF.

Article PDF first page preview

Article PDF first page preview
You do not currently have access to this content.