This paper studies the dynamic characteristic of the truss Spar-type floating foundation used to support the offshore vertical-axis wind turbine (VAWT). The effects of changes in foundation structural parameters on its motions were evaluated. The results show that radius of the buoyancy tank, radius of the upper mechanical tank, interval of the center of gravity and center of buoyancy, and height of the upper mechanical tank have important effects on the heave and pitch motions of the foundation. Two sets of foundation parameters (FS-1 and FS-2) were selected to support the 5 MW Darrieus wind turbine. The motion performances of the two floating VAWTs, S-1 (the VAWT supported by FS-1) and S-2 (the VAWT supported by FS-2), were analyzed and compared. It was observed that the amplitudes of the heave and pitch motions of the floating VAWT depend on the wave loads; the mean values of the heave and pitch motions depend on the aerodynamic loads. The floating VAWT S-2 had better motion performance; its heave and pitch motions were all small. The heave frequencies of the floating VAWT were equal to the wave frequencies. For the pitch frequencies, there is a component of the rotor rotational frequency (0.175 Hz) for cases LC1 to LC4, while the amplitudes of the twice-per-revolution (2P) response are far smaller than the amplitudes of the wave response.
Skip Nav Destination
Article navigation
December 2017
Research-Article
Dynamic Analysis of a Truss Spar-Type Floating Foundation for 5 MW Vertical-Axis Wind Turbine
Liqin Liu,
Liqin Liu
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: liuliqin@tju.edu.cn
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: liuliqin@tju.edu.cn
Search for other works by this author on:
Weichen Jin,
Weichen Jin
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: blue_sky_jin@126.com
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: blue_sky_jin@126.com
Search for other works by this author on:
Ying Guo
Ying Guo
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: yynocry@tju.edu.cn
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: yynocry@tju.edu.cn
Search for other works by this author on:
Liqin Liu
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: liuliqin@tju.edu.cn
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: liuliqin@tju.edu.cn
Weichen Jin
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: blue_sky_jin@126.com
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: blue_sky_jin@126.com
Ying Guo
State Key Laboratory of Hydraulic Engineering
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: yynocry@tju.edu.cn
Simulation and Safety,
Tianjin University,
Tianjin 300072, China
e-mail: yynocry@tju.edu.cn
1Corresponding author.
Contributed by the Ocean, Offshore, and Arctic Engineering Division of ASME for publication in the JOURNAL OF OFFSHORE MECHANICS AND ARCTIC ENGINEERING. Manuscript received September 30, 2016; final manuscript received June 12, 2017; published online August 16, 2017. Assoc. Editor: Yin Lu Young.
J. Offshore Mech. Arct. Eng. Dec 2017, 139(6): 061902 (9 pages)
Published Online: August 16, 2017
Article history
Received:
September 30, 2016
Revised:
June 12, 2017
Citation
Liu, L., Jin, W., and Guo, Y. (August 16, 2017). "Dynamic Analysis of a Truss Spar-Type Floating Foundation for 5 MW Vertical-Axis Wind Turbine." ASME. J. Offshore Mech. Arct. Eng. December 2017; 139(6): 061902. https://doi.org/10.1115/1.4037292
Download citation file:
260
Views
Get Email Alerts
Cited By
Torus-Shaped Wave Energy Converter Attached to a Hinged Arm
J. Offshore Mech. Arct. Eng
DYNAMIC SIMULATION OF AN OFFSHORE AQUACULTURE STRUCTURE SUBJECTED TO COMBINED WAVE AND CURRENT CONDITIONS
J. Offshore Mech. Arct. Eng
Optimization of steel jackets to support offshore wind turbines using evolutionary algorithms
J. Offshore Mech. Arct. Eng
Numerical Study on Modeling and Local Characteristics of a Predetermined Freak Wave
J. Offshore Mech. Arct. Eng (February 2024)
Related Articles
Automatic System for Wind Turbine Testing
J. Sol. Energy Eng (November,2001)
Numerical and Experimental Investigation of the Performance of a Vertical Axis Wind Turbine Based on the Magnetic Levitation Concept
J. Energy Resour. Technol (September,2022)
Extreme Dynamic Structural Response Analysis of Catenary Moored Spar Wind Turbine in Harsh Environmental Conditions
J. Offshore Mech. Arct. Eng (November,2011)
Alternative Composite Materials for Megawatt-Scale Wind Turbine Blades: Design Considerations and Recommended Testing
J. Sol. Energy Eng (November,2003)
Related Proceedings Papers
Related Chapters
CFD Analysis of Multiple VAWTs Sited in Tandem and T-Type Configurations
International Conference on Advanced Computer Theory and Engineering, 5th (ICACTE 2012)
Neural Network Approach for Estimating Mass Moments of Inertia and Center of Gravity in Military Vehicles
Intelligent Engineering Systems through Artificial Neural Networks, Volume 16
Energy Resources at Malaysian Sedimentary Basins and Spar Platform as Deep Sea Structure
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3