The design of power transmission lines requires a knowledge of combined wind and ice loading and of the dynamic behavior of wires loaded with ice accretion. The calculation of the wind forces, in turn, imposes a need for a more detailed computer model for determining glaze accretion shape. For this purpose, a computer model of glaze accretion on wires, was developed. It is based on experimental results in the area of ice accretion on wires, as well as on results in the related field of the glaze ice accretion on airfoils. The model incorporates the time dependent on feedback between the growing accretion and the air stream, the variation of the heat transfer coefficient around the cylinder, and the surface runback of water. The main components of the model are the computation of the air flow field, the computation of the impingement water at the control volume level, the solving of the heat balance equation, and the computation of the accretion shape on the wire. The surface air velocity is obtained through the solution of the potential flow around the iced wire and wake, followed by the integration on the surface of the laminar boundary layer. The water flux is computed in each control Volume down to the separation point. The heat balance equation derived from the energy equation is solved to determine the freezing fraction and the resulting modified ice surface geometry.

1.
Ackley, S. F., and Templeton, M. K., 1979, “Computer Modelling of Atmospheric Ice Accretion,” CRREL, Rep. 79, 4.
2.
Al-Khalil
K. M.
,
Keith
T. G.
, and
De Witt
K. J.
,
1993
, “
New Concept in Runback Water Modelling for Anti-Iced Aircraft Surfaces
,”
Journal of Aircraft
, Vol.
30
, No.
1
, pp.
41
49
.
3.
Al-Khalil
K. M.
,
Keith
T. G.
,
De Witt
K. J.
,
1994
, “
Development of an Improved Model for Runback Water on Aircraft Surfaces
,”
Journal of Aircraft
, Vol.
31
, No.
2
, pp.
271
278
.
4.
Best
A. C.
,
1950
, “
The Size Distribution of Rain Drops
,”
Quarterly Journal of Royal Meteorology Society
, Vol.
76
, pp.
16
36
.
5.
Bouchard, G., and McComber, P., 1992, “Numerical Computation of the Quasi-Steady Wind Forces on a Noncircular Two-Dimensional Shape,” International Symposium on Flow-Induced Vibrations and Noise, Anaheim, CA, November 9–13.
6.
Buchan, P. G., 1977, “The Artificial Deposition of Ice on Transmission Line Conductors—A Study of Profile Shape,” Ontario Hydro Research Report, No.77–387-K, September 1.
7.
Buchan, P. G., 1978, “Static Measurements of the Aerodynamic Lift, Drag and Moment Forces Acting on a Short Section of Artificially Iced 795 KCMILACSR Conductor,” Ontario Hydro Research Division Report, No. 78–205-K, April 28.
8.
Diem, M., 1956, “Ice Hoods on High Voltage Conductors in Mountain,” Archiv fur Meteorologie Geophysic und Bioklimatologie, Ser. B, No. B7, pp. 89–95.
9.
Gland, H., 1985, “Givre, verglas, neige collante: nature des phe´nome`nes et situations me´te´orologiques correspondantes,” Journe´e d’ e´tudes de la SEE sur les lignes ae´riennes face a` l’environnement climatique, Gif-sur-Yvette, France, pp. 5–11.
10.
Gunn
R.
, and
Kinzer
G. D.
,
1949
, “
The Terminal Velocity of Fall for Water Droplets in Stagnant Air
,”
Journal of Meteorology
, Vol.
6
, pp.
243
248
.
11.
Horjen, I., 1983, Icing on Offshore Structures-Atmospheric Icing, Norwegian Maritime Research, No. 3.
12.
Lozowski
E. P.
,
Stallabras
J. R.
, and
Hearty
P. F.
,
1983
a, “
The Icing of an Unheated, Nonrotating Cylinder, Part I: A Simulation Model
,”
Journal of Cl. and Applied Meteorology
, Vol.
22
, Dec., pp.
2053
2063
.
13.
Lozowski
E. P.
,
Stallabras
J. R.
, and
Hearty
P. F.
,
1983
b, “
The Icing of an Unheated, Nonrotating Cylinder, Part II: Icing Wind Tunnel Experiments
,”
Journal of Cl. and Applied Meteorology
, Vol.
22
, Dec., pp.
2063
2074
.
14.
Makkonen
L.
,
1981
, “
Estimating Intensity of Atmospheric Ice Accretion on Stationary Structures
,”
Journal of Cl. and Applied Meteorology
, Vol.
20
, pp.
595
600
.
15.
Makkonen
L.
,
1984
, “
Modelling of Ice Accretion on Wires
,”
Journal of Cl. and Applied Meteorology
, Vol.
23
, pp.
929
939
.
16.
Makkonen
L.
,
1985
, “
Heat Transfer and Icing of a Rough Cylinder
,”
Cold Regions Science and Technology
, Vol.
10
, pp.
105
116
.
17.
Makkonen
L.
,
1988
, “
A Model of Icicle Growth
,”
Journal of Glaciology
, Vol.
34
, pp.
64
70
.
18.
Makkonen
L.
, and
Fujii
Y.
,
1993
, “
Spacing of Icicles
,”
Cold Regions Science and Technology
, Vol.
21
, pp.
317
322
.
19.
Messinger, B. L., 1953, “Equilibrium Temperature of an Unheated Icing Surface as a Function of Air Speed,” Journal of the Aeronautical Sciences, Jan.
20.
Nigol, O., 1976, “Galloping Control for Single and Bundle Conductors by Torsional Stiffness,” Ontario Hydro Research Report No 76-163-K.
21.
Olsen, W., 1985, “Close-up Movies of the Icing Process on the Leading Edge of an Airfoil,” NASA Lewis Research Center Movie C-313.
22.
Olsen, W., and Walker, E., 1986, “Experimental Evidence for Modifying the Current Phisical Model for Ice Accretion on Aircraft Surfaces,” NASA TM-87184, May.
23.
Personne
P.
, and
Gayet
J. F.
,
1988
, “
Ice Accretion on Wires and Anti-icing Induced by Joule Effect
,”
Journal of Applied Meteorology
, Vol.
27
, Feb., pp.
101
114
.
24.
Ruff, G. A., and Berkowitz, B. M., 1990, “User’s Manual for the NASA Lewis Ice Accretion Prediction Code (LEWICE),” NASA CR-185129, May.
25.
Scott, J. N., Hankey, W. L., Giesler, F. J., and Gielda, T. P., 1987, “Navier-Stokes Solution to the Flowfield Over Ice Accretion Shapes,” Vol. 25, No. 8, pp. 710–716.
26.
Schlichting, H., 1987, Boundary Layer Theory, McGraw-Hill Book Co., New York, NY.
27.
Schmidt, E., Wenner, K., 1941, “Heat Transfer over the Circumference of a Heated Cylinder in Transverse Flow,” NACA TM 1050.
28.
Shin, J., Berkowitz, B., Chen, H. H., and Cebeci, T., 1994, “Prediction of Ice Shapes and Their Effect on Airfoil Drag,” Journal of Aircraft, Vol. 31, No. 2.
29.
Smith
A. G.
, and
Spalding
D. D.
,
1958
, “
Heat Transfer in a Laminar Boundary Layer with Constant Fluid Properties and Constant Wall Temperature
,”
Journal of Royal Aeronautical Society
, Vol.
62
, pp.
60
64
.
30.
Szilder
K.
,
Lozowski
E. P.
, and
Gates
E. M.
,
1987
, “
Modelling Ice Accretion Non-Rotating Cylinders—The Incorporation of Time Dependence and Internal Heat Conduction
,”
Cold Regions Science and Technology
, Vol.
13
, pp.
177
191
.
31.
Thwaites
B.
,
1949
, “
Approximate Calculation of the Laminar Boundary Layer
,”
Aeronautics Quarterly
, Vol.
1
, p.
245
245
.
32.
Walz
A.
,
1941
, “
Ein neuer Ansatz fur das Geschwindigkeitsprofil der laminaren Reibungss chicht
,”
Liliental-Bericht
, Vol.
141
, p.
8
8
.
33.
Zukauskas, A., and Ziugzda, J., 1985, Heat Transfer of a Cylinder in Crossflow, Hemisphere Publishing Corporation.
This content is only available via PDF.
You do not currently have access to this content.