This paper presents a technique, based on Monte-Carlo simulations, of utilizing a screw over its yield point in a controlled fashion, even under simple tightening conditions. The simulations consider the probabilistic nature of different variables necessary to calculate screwed joints. The proposed torque and angle controlled tightening technique can be used in assembly plants as well as in small workshops. The technique predicts permanent elongation, maximum tightening angle, final torque and preload after tightening. Further, a recommendation on the minimum and maximum snug torques prior to application of the angle over the yield point of a screw is also presented.
Torque and Angle Controlled Tightening Over the Yield Point of a Screw—Based on Monte-Carlo Simulations
Contributed by the Reliability Stress Analysis and Failure Preubation Committee for publication in the JOURNAL OF MECHANICAL DESIGN. Manuscript received October 2002; revised October 2003. Associate Editor: J. C. Moosbrugger.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Toth, G. R. (August 12, 2004). "Torque and Angle Controlled Tightening Over the Yield Point of a Screw—Based on Monte-Carlo Simulations ." ASME. J. Mech. Des. July 2004; 126(4): 729–736. https://doi.org/10.1115/1.1701877
Download citation file:
- Ris (Zotero)
- Reference Manager