This article addresses parallel manipulators with fewer than six degrees of freedom, whose use may prove valuable in those applications in which a higher mobility is uncalled for. In particular, a family of 3-dof manipulators containing only revolute joints or at the most revolute and prismatic ones is studied. Design and assembly conditions sufficient to provide the travelling platform with a pure translational motion are determined and two sub-families that fulfill the imposed constraint are found: one is already known in the literature, while the other is original. The new architecture does not exhibit rotation singularities, i.e., configurations in which the platform gains rotational degrees of freedom. A geometric interpretation of the translation singularities is provided.
A Family of 3-DOF Translational Parallel Manipulators1
Contributed by the Mechanisms and Robotics Committee for publication in the JOURNAL OF MECHANICAL DESIGN. Manuscript received May 2001; revised October 2002. Associate Editor: G. S. Chirikjian.
- Views Icon Views
- Share Icon Share
- Search Site
Carricato, M., and Parenti-Castelli, V. (June 11, 2003). "A Family of 3-DOF Translational Parallel Manipulators." ASME. J. Mech. Des. June 2003; 125(2): 302–307. https://doi.org/10.1115/1.1563635
Download citation file: