Consideration of diagnosability in product design promises to increase product quality by reducing maintenance time without increasing cost or decreasing reliability. Methods for investigating the diagnosability of mechanical and electro-mechanical systems are described and are applied to the Bleed Air Control System (BACS) on the Boeing 747-400. The BACS is described and a diagnostic model is developed using information from the system Failure Modes and Effects Analysis. Emphasis is placed on the relationships between the system’s functions and its components. Two metrics for the evaluation of system diagnosability and two metrics for the evaluation of component diagnosability are defined. These metrics emphasize diagnostic ambiguity and are combined with the probability of different system failures to weight the effects of each failure. Three modified systems are produced by reassigning functions from one component to another. The resulting effects on the system and component diagnosability are evaluated. We show that by changing these relationships system diagnosability can be improved without adding sensors or other components.

DoD, 1988, Handbook 791, Maintainability Design Techniques, Department of Defense, Washington, DC.
Jones, J. V., 1988, Engineering Design: Reliability, Maintainability, and Testability, TAB Books, Blue Ridge Summit, PA.
Kapur, K. C., 1988, “Techniques of Estimating Reliability at Design Stage,” Handbook of Reliability Engineering and Management, W. G. Ireson and C. F. Coombs, Jr., eds., McGraw-Hill, New York.
Liu, B. D., and Sheu, J. J., 1991 “A New Low Overhead Design for Testability of Programmable Logic Arrays,” IEEE International Symposium on Circuit Systems, Vol. 4, pp. 1972–75.
Misra, A., et al., 1992, “Diagnosability of Dynamical Systems,” Proceedings of the 3rd International Workshop on Principles of Diagnosis, Rosario, WA, pp. 239–44.
Ruff, D. N., and Paasch, R. K., 1993, “Consideration of Failure Diagnosis in Conceptual Design of Mechanical Systems,” Proceedings of the Fifth International Conference on Design Theory and Methodology, Albuquerque, NM, pp. 175–187.
Stander, C., 1982, “Fault Isolation BITE for Increased Productivity,” Proceedings, Annual Reliability and Maintainability Symposium 1982, Institute of Electrical and Electronics Engineers, New York, pp. 365–369.
Ullman, D. G., 1992, The Mechanical Design Process, McGraw-Hill, New York.
Yu, X., and Biswas, G., 1992, “A Method for Diagnosis of Continuous-Valued Systems,” Proceedings of the 3rd International Workshop on Principles of Diagnosis, Rosario, WA, pp. 57–65.
This content is only available via PDF.
You do not currently have access to this content.