A closed-form inverse force analysis was performed on a planar two-spring system. The two springs were grounded to pivots at one end and attached to a common pivot at the other. A known force was applied to the common pivot of the system, and it was required to determine all of the assembly configurations. By variable elimination, a sixth degree polynomial in the resultant length of one spring was derived, and from this, six real solutions of the point of application of force were obtained. Following this, the applied force was incremented along a line and the six paths of the moving pivot were tracked starting from the zero-load configurations. An analysis of these results showed stability phenomena indicating the workspace of this system contained regions of negative spring stiffness and points of catastrophe.

Arnol’d, V., 1992, Catastrophe Theory, Springer Verlag, Berlin, Heidelberg.
Dijksman, J., 1979, “A Study of Some Aspects of the Mechanical Behavior of Cross-Spring Pivots and Plate Spring Mechanisms with Negative Stiffness,” Ph.D. Dissertation, Delft University of Technology, Amsterdam, Holland.
Eijk, J., 1985, “On the Design of Plate Spring Mechanisms,” Ph.D. Dissertation, Delft University of Technology, Amsterdam, Holland.
Eijk, J., and Dijksman, J., 1976, “Plate Spring Mechanisms with Constant Negative Stiffness,” VakGroep Fijnmechanische Techniek, June.
Griffis, M., and Duffy, J., 1992, “Comparing Structures of Stiffness Matrices Using Invariants,” Proceedings, VII CISM-IFToMM Symposium “Ro. Man. Sy ’92”.
Griffis, M., 1991, “Kinestatic Control: A Novel Theory for Simultaneously Regulating Force and Displacement,” Ph.D. Dissertation, University of Florida, Gainesville, FL.
Haringx, J., 1950, “Instability of Springs,” Phillips Technical Review, Vol. 11, No. 8.
Haringx, J., 1949, “Elastic Stability of Helical Springs at a Compression Larger than Original Length,” Applied Scientific Research, A1, pp. 417–434.
Haringx, J., 1947, “On Highly Compressible Helical Spring and Rubber Bars and Their Application in Vibration Isolation,” Ph.D. Dissertation, Delft University of Technology, Amsterdam, Holland.
Haringx, J., 1942, “On the Buckling and the Lateral Rigidity of Helical Compression Springs,” Proc. Ned. Akad. Wetenschappen, Amsterdam 45.
Loncaric, J., 1985, “Geometric Analysis of Compliant Mechanisms in Robotics,” Ph.D. Thesis, Harvard University, Cambridge, MA.
Pigoski, T., Griffis, M., and Duffy, J., 1992, “Stiffness Mappings Employing Different Frames of Reference,’ Flexible Mechanisms, Dynamics, and Analysis, DE-Vol. 47, ASME Design Technical Conference 1992.
Seirig, A., 1969, Mechanical System Analysis, International Textbook, PA.
Vanderplaats, G., 1984, Numerical Optimization Techniques for Engineering Design: With Applications, McGraw Hill, New York.
Zeeman, E., 1977, Catastrophe Theory: Selected Papers 1972–1977, Addison-Wesley Advanced Book Program, Boston, MA.
This content is only available via PDF.
You do not currently have access to this content.