The hot flow stress of a typical stainless steel was modeled by the Hollomon equation, a modified form of the Hollomon equation, and another modified form based on the Fields–Backofen equation. The coupled effect of the deformation temperature and strain rate was also taken into account in the proposed formulae by consideration of the Zener–Hollomon parameter or dependency of the constants on temperature. The modified Fields–Backofen equation was found to be appropriate for prediction of flow stress, in which the incorporation of peak strain and consideration of temperature dependencies of the strain rate sensitivity and the stress coefficient were found to be beneficial. Moreover, the simplicity of the proposed model justifies its applicability for expressing hot flow stress characterizing dynamic recrystallization (DRX).
Issue Section:
Research Papers
References
1.
Anand
, L.
, 1982
, “Constitutive Equations for the Rate-Dependent Deformation of Metals at Elevated Temperatures
,” ASME J. Eng. Mater. Technol.
, 104
(1
), pp. 12
–17
.2.
Mirzadeh
, H.
, 2014
, “Constitutive Analysis of Mg–Al–Zn Magnesium Alloys During Hot Deformation
,” Mech. Mater.
, 77
, pp. 80
–85
.3.
Spigarelli
, S.
, and El Mehtedi
, M.
, 2014
, “A New Constitutive Model for the Plastic Flow of Metals at Elevated Temperatures
,” J. Mater. Eng. Perform.
, 23
(2
), pp. 658
–665
.4.
Mohamadizadeh
, A.
, Zarei-Hanzaki
, A.
, Abedi
, H. R.
, Mehtonen
, S.
, and Porter
, D.
, 2015
, “Hot Deformation Characterization of Duplex Low-Density Steel Through 3D Processing Map Development
,” Mater. Charact.
, 107
, pp. 293
–301
.5.
Lin
, Y. C.
, Chen
, X. M.
, Wen
, D. X.
, and Chen
, M. S.
, 2014
, “A Physically-Based Constitutive Model for a Typical Nickel-Based Superalloy
,” Comput. Mater. Sci.
, 83
, pp. 282
–289
.6.
Mirzadeh
, H.
, 2015
, “A Simplified Approach for Developing Constitutive Equations for Modeling and Prediction of Hot Deformation Flow Stress
,” Metall. Mater. Trans. A
, 46
(9
), pp. 4027
–4037
.7.
Lin
, Y. C.
, and Chen
, X.-M.
, 2011
, “A Critical Review of Experimental Results and Constitutive Descriptions for Metals and Alloys in Hot Working
,” Mater. Des.
, 32
(4
), pp. 1733
–1759
.8.
Gronostajski
, Z.
, 2000
, “The Constitutive Equations for FEM Analysis
,” J. Mater. Process. Technol.
, 106
, pp. 40
–44
.9.
Lin
, Y. C.
, He
, M.
, Zhou
, M.
, Wen
, D. X.
, and Chen
, J.
, 2015
, “New Constitutive Model for Hot Deformation Behaviors of Ni-Based Superalloy Considering the Effects of Initial δ Phase
,” J. Mater. Eng. Perform.
, 24
(9
), pp. 3527
–3538
.10.
Cheng
, Y. Q.
, Zhang
, H.
, Chen
, Z. H.
, and Xian
, K. F.
, 2008
, “Flow Stress Equation of AZ31 Magnesium Alloy Sheet During Warm Tensile Deformation
,” J. Mater. Process. Technol.
, 208
, pp. 29
–34
.11.
Mirzadeh
, H.
, 2015
, “Quantification of the Strengthening Effect of Reinforcements During Hot Deformation of Aluminum-Based Composites
,” Mater. Des.
, 65
, pp. 80
–82
.12.
Lin
, Y. C.
, Chen
, M. S.
, and Zhong
, J.
, 2008
, “Constitutive Modeling for Elevated Temperature Flow Behavior of 42CrMo Steel
,” Comput. Mater. Sci.
, 42
(3
), pp. 470
–477
.13.
Puchi Cabrera
, E. S.
, 2001
, “A Constitutive Description of Aluminum-1% Magnesium Alloy Deformed Under Hot-Working Conditions
,” ASME J. Eng. Mater. Technol.
, 123
(3
), pp. 301
–308
.14.
Mandal
, S.
, Sivaprasad
, P. V.
, and Venugopal
, S.
, 2007
, “Capability of a Feed-Forward Artificial Neural Network to Predict the Constitutive Flow Behavior of as Cast 304 Stainless Steel Under Hot Deformation
,” ASME J. Eng. Mater. Technol.
, 129
(2
), pp. 242
–247
.15.
Mirzadeh
, H.
, Roostaei
, M.
, Parsa
, M. H.
, and Mahmudi
, R.
, 2015
, “Rate Controlling Mechanisms During Hot Deformation of Mg–3Gd–1Zn Magnesium Alloy: Dislocation Glide and Climb, Dynamic Recrystallization, and Mechanical Twinning
,” Mater. Des.
, 68
, pp. 228
–231
.16.
Lin
, Y. C.
, Wen
, D. X.
, Deng
, J.
, Liu
, G.
, and Chen
, J.
, 2014
, “Constitutive Models for High-Temperature Flow Behaviors of a Ni-Based Superalloy
,” Mater. Des.
, 59
, pp. 115
–123
.17.
Quan
, G.
, Tong
, Y.
, Luo
, G.
, and Zhou
, J.
, 2010
, “A Characterization for the Flow Behavior of 42CrMo Steel
,” Comput. Mater. Sci.
, 50
(1
), pp. 167
–171
.18.
Lin
, Y. C.
, Li
, L. T.
, and Jiang
, Y. Q.
, 2012
, “A Phenomenological Constitutive Model for Describing Thermo-Viscoplastic Behavior of Al–Zn–Mg–Cu Alloy Under Hot Working Condition
,” Exp. Mech.
, 52
(8
), pp. 993
–1002
.19.
Xu
, W.
, Zou
, M.
, and Zhang
, L.
, 2014
, “Constitutive Analysis to Predict the Hot Deformation Behavior of 34CrMo4 steel With an Optimum Solution Method for Stress Multiplier
,” Int. J. Pressure Vessels Piping
, 123–124
, pp. 70
–76
.20.
Mirzadeh
, H.
, Cabrera
, J. M.
, and Najafizadeh
, A.
, 2011
, “Constitutive Relationships for Hot Deformation of Austenite
,” Acta Mater.
, 59
(16
), pp. 6441
–6448
.21.
Hollomon
, J. H.
, 1945
, “Tensile Deformation
,” Trans. AIME
, 162
, pp. 268
–290
.22.
Fields
, D. S.
, and Backofen
, W. A.
, 1957
, “Determination of Strain Hardening Characteristics by Torsion Testing
,” Proc. Am. Soc. Test. Mater.
, 57
, pp. 1259
–1272
.23.
Johnson
, G. R.
, and Cook
, W. H.
, 1983
, “A Constitutive Model and Data for Metals Subjected to Large Strains, High Strain Rates and High Temperatures
,” Seventh International Symposium on Ballistic
, The Hague, The Netherlands, Apr. 19–21, pp. 541
–547
.24.
Mirzadeh
, H.
, 2015
, “Constitutive Modeling and Prediction of Hot Deformation Flow Stress Under Dynamic Recrystallization Conditions
,” Mech. Mater.
, 85
, pp. 66
–79
.25.
Akbari
, Z.
, Mirzadeh
, H.
, and Cabrera
, J. M.
, 2015
, “A Simple Constitutive Model for Predicting Flow Stress of Medium Carbon Microalloyed Steel During Hot Deformation
,” Mater. Des.
, 77
, pp. 126
–131
.26.
Zener
, C.
, and Hollomon
, J. H.
, 1944
, “Effect of Strain Rate Upon Plastic Flow of Steel
,” J. Appl. Phys.
, 15
(1
), pp. 22
–32
.27.
McQueen
, H. J.
, and Ryan
, N. D.
, 2002
, “Constitutive Analysis in Hot Working
,” Mater. Sci. Eng. A
, 322
, pp. 43
–63
.28.
Mirzadeh
, H.
, and Najafizadeh
, A.
, 2010
, “Prediction of the Critical Conditions for Initiation of Dynamic Recrystallization
,” Mater. Des.
, 31
(3
), pp. 1174
–1179
.29.
Poliak
, E. I.
, and Jonas
, J. J.
, 1996
, “A One-Parameter Approach to Determining the Critical Conditions for the Initiation of Dynamic Recrystallization
,” Acta Mater.
, 44
(1
), pp. 127
–136
.30.
Mirzadeh
, H.
, 2015
, “Constitutive Description of 7075 Aluminum Alloy During Hot Deformation by Apparent and Physically-Based Approaches
,” J. Mater. Eng. Perform.
, 24
(3
), pp. 1095
–1099
.31.
Sellars
, C. M.
, and McTegart
, W. J.
, 1966
, “On the Mechanism of Hot Deformation
,” Acta Metall.
, 14
(9
), pp. 1136
–1138
.32.
Mirzadeh
, H.
, 2015
, “Constitutive Behaviors of Magnesium and Mg–Zn–Zr Alloy During Hot Deformation
,” Mater. Chem. Phys.
, 152
, pp. 123
–126
.33.
Mirzadeh
, H.
, Cabrera
, J. M.
, Prado
, J. M.
, and Najafizadeh
, A.
, 2011
, “Hot Deformation Behavior of a Medium Carbon Microalloyed Steel
,” Mater. Sci. Eng. A
, 528
, pp. 3876
–3882
.34.
Mirzadeh
, H.
, 2014
, “A Comparative Study on the Hot Flow Stress of Mg–Al–Zn Magnesium Alloys Using a Simple Physically-Based Approach
,” J. Magnesium Alloys
, 2
(3
), pp. 225
–229
.35.
Mirzadeh
, H.
, 2015
, “Physically Based Constitutive Description of OFHC Copper at Hot Working Conditions
,” Kovove Mater.
, 53
, pp. 105
–111
.36.
Mirzadeh
, H.
, 2015
, “Simple Physically-Based Constitutive Equations for Hot Deformation of 2024 and 7075 Aluminum Alloys
,” Trans. Nonferrous Met. Soc. China
, 25
(5
), pp. 1614
–1618
.37.
Saadatkia
, S.
, Mirzadeh
, H.
, and Cabrera
, J. M.
, 2015
, “Hot Deformation Behavior, Dynamic Recrystallization, and Physically-Based Constitutive Modeling of Plain Carbon Steels
,” Mater. Sci. Eng. A
, 636
, pp. 196
–202
.38.
Cabrera
, J. M.
, Al Omar
, A.
, Jonas
, J. J.
, and Prado
, J. M.
, 1997
, “Modeling the Flow Behavior of a Medium Carbon Microalloyed Steel Under Hot Working Conditions
,” Metall. Mater. Trans. A
, 28
(11
), pp. 2233
–2244
.39.
Langdon
, T. G.
, 2005
, “An Analysis of Flow Mechanisms in High Temperature Creep and Superplasticity
,” Mater. Trans.
, 46
(9
), pp. 1951
–1956
.40.
Mukherjee
, A. K.
, 2002
, “An Examination of the Constitutive Equations for Elevated Temperature Plasticity
,” Mater. Sci. Eng. A
, 322
, pp. 1
–22
.Copyright © 2016 by ASME
You do not currently have access to this content.
