Texture formation and Swift effect were investigated in torsion deformed NiAl. High-strain torsion of solid bars was done with a Paterson rock deformation machine at temperatures between 700 K and 1300 K under a confining pressure of 400 MPa. The maximum shear strains and shear strain rates applied were 19×104s1 and 2.2×104s1, respectively. Textures were measured by diffraction of neutrons, electrons, and synchrotron radiation. The textures consist of an oblique cube and Goss component, the intensity of which depends on the initial texture and deformation temperature. The axial lengthening and shortening observed are related to the Goss and the oblique cube components, respectively. There is qualitative agreement between experiment and simulation at low temperature and low shear strains. With increasing temperature, continuous and discontinuous dynamic recrystallization take place, strongly influencing the development of texture and Swift effect.

1.
Klöden
,
B.
,
Rybacki
,
E.
,
Oertel
,
C. -G.
, and
Skrotzki
,
W.
, 2007, “
Grain Refinement and Texture Formation in Torsion Deformed NiAl
,”
Int. J. Mater. Res.
1862-5282,
98
, pp.
276
282
.
2.
Valiev
,
R. Z.
,
Estrin
,
Y.
,
Horita
,
Z.
,
Langdon
,
T. G.
,
Zehetbauer
,
M. J.
, and
Zhu
,
Y. T.
, 2006, “
Producing Bulk Ultrafine-Grained Materials by Severe Plastic Deformation
,”
JOM
1047-4838,
58
, pp.
33
39
.
3.
Klöden
,
B.
,
Oertel
,
C. -G.
,
Skrotzki
,
W.
, and
Rybacki
,
E.
, 2009, “
Microstructure Development During High Strain Torsion of NiAl
,”
ASME J. Eng. Mater. Technol.
0094-4289,
131
(
1
), p.
011101
.
4.
Swift
,
H. W.
, 1947, “
Length Changes in Metals Under Torsional Overstrain
,”
Engineering (London)
0013-7782,
163
, pp.
253
257
.
5.
Montheillet
,
F.
,
Cohen
,
M.
, and
Jonas
,
J. J.
, 1984, “
Axial Stresses and Texture Development During the Torsion Testing of Al, Cu and α-Fe-Fe
,”
Acta Metall.
0001-6160,
32
, pp.
2077
2089
.
6.
Tóth
,
L. S.
, and
Jonas
,
J. J.
, 1989, “
Analytic Prediction of Texture and Length Changes During Free-End Torsion
,”
Textures Microstruct.
0730-3300,
10
, pp.
195
209
.
7.
Tóth
,
L. S.
,
Szaszvari
,
P.
,
Kovacs
,
I.
, and
Jonas
,
J. J.
, 1991, “
Shortening Behavior of Twisted Copper Wires
,”
Textures Microstruct.
0730-3300,
14–18
, pp.
995
1000
.
8.
Tóth
,
L. S.
,
Jonas
,
J. J.
,
Daniel
,
D.
, and
Bailey
,
J. A.
, 1992, “
Texture Development and Length Changes in Copper Bars Subjected to Free End Torsion
,”
Textures Microstruct.
0730-3300,
19
, pp.
245
262
.
9.
Böhlke
,
T.
, 2001, “
Crystallographic Texture Evolution and Elastic Anisotropy
,” Habilitation thesis, University of Magdeburg, Magdeburg.
10.
Tóth
,
L. S.
,
Qods
,
F.
, and
Fundenberger
,
J. J.
, 2005, “
Modeling of Axial Strain in Free-End Torsion of Textured Copper
,”
Z. Metallk.
,
96
, pp.
1038
1043
. 0044-3093
11.
Böhlke
,
T.
,
Glüge
,
R.
,
Klöden
,
B.
,
Skrotzki
,
W
., and
Bertram
,
A
., 2007, “
Finite Element Simulation of Texture and Swift Effect in NiAl Under Torsion
,”
Modell. Simul. Mater. Sci. Eng.
,
15
, pp.
619
637
. 0965-0393
12.
Paterson
,
M. S.
, and
Olgaard
,
D. L.
, 2000, “
Rock Deformation Tests to Large Shear Strains in Torsion
,”
J. Struct. Geol.
0191-8141,
22
, pp.
1341
1358
.
13.
Brokmeier
,
H. -G.
, 1995, “
Texturanalyse Mittels Winkeldispersiver Neutronographischer Kernstreuung
,” Habilitation thesis, TU Clausthal, Clausthal-Zellerfeld.
14.
Wcislak
,
L.
,
Klein
,
H.
,
Bunge
,
H. J.
,
Garbe
,
U.
,
Tschentscher
,
T.
, and
Schneider
,
J. R.
, 2002, “
Texture Analysis With High-Energy Synchrotron Radiation
,”
J. Appl. Crystallogr.
0021-8898,
35
, pp.
82
95
.
15.
Skrotzki
,
W.
,
Klöden
,
B.
,
Tamm
,
R.
,
Oertel
,
C. -G.
,
Garbe
,
U.
, and
Rybacki
,
E.
, 2003, “
Torsion Texture Measurements With High-Energy Synchrotron Radiation on NiAl
,”
Textures Microstruct.
0730-3300,
35
, pp.
163
173
.
16.
Dahms
,
M.
, and
Eschner
,
T.
, 1996, “
Quantitative Texturanalyse durch iterative Reihenzerlegung von Beugungs-Polfiguren
,” Software Manual.
17.
Bunge
,
H. J.
, 1982,
Texture Analysis in Materials Science
,
Butterworth
,
London
.
18.
Tóth
,
L. S.
, and
Molinari
,
A.
, 1994, “
Tuning a Self Consistent Viscoplastic Model by Finite Element Results—II. Application to Torsion Textures
,”
Acta Metall. Mater.
,
42
, pp.
2459
2466
. 0956-7151
19.
Qods
,
F.
,
Tóth
,
L. S.
, and
Van Houtte
,
P.
, 2005, “
Modeling of Length Changes and Textures During Free End Torsion of Cylindrical Bars
,”
Mater. Sci. Forum
0255-5476,
495–497
, pp.
1609
1614
.
20.
Tóth
,
L. S.
, 2000, “
Texture Related Effects in the Mechanics of Torsion
,”
Proceedings of J. J. Jonas Symposium on Thermomechanical Processing of Steel
,
S.
Yue
and
E.
Es-Sadiqi
, eds.,
Metallurgical Society
, Canadian Institute of Mining, Metallurgy and Petroleum,
Canada
, pp.
109
120
.
21.
Klöden
,
B.
, 2006, “
Microstructure and Texture Development During High-Strain Torsion of NiAl
,” Ph.D. thesis, TU Dresden, Dresden.
22.
Gourdet
,
S.
, and
Montheillet
,
F.
, 2000, “
An Experimental Study of the Recrystallization Mechanism During Hot Deformation of Aluminium
,”
Mater. Sci. Eng., A
0921-5093,
283
, pp.
274
288
.
23.
Montheillet
,
F.
, and
Le Coze
,
J.
, 2002, “
Influence of Purity on the Dynamic Recrystallization of Metals and Alloys
,”
Phys. Status Solidi A
,
189
, pp.
51
58
. 0031-8957
24.
Gourdet
,
S.
, and
Montheillet
,
F.
, 2002, “
Effects of Dynamic Grain Boundary Migration During the Hot Compression of High Stacking Fault Energy Metals
,”
Acta Mater.
,
50
, pp.
2801
2812
. 1359-6454
25.
Gourdet
,
S.
, and
Montheillet
,
F.
, 2003, “
A Model of Continuous Dynamic Recrystallization
,”
Acta Mater.
,
51
, pp.
2685
2699
. 1359-6454
26.
Montheillet
,
F.
, 2004, “
Moving Grain Boundaries During Hot Deformation of Metals: Dynamic Recrystallization
,”
Moving Interfaces in Crystalline Solids
(
CISM Courses and Lectures
), Vol.
453
,
Springer
,
New York
, pp.
203
256
.
27.
Caillard
,
D.
,
Vailhé
,
C.
, and
Farkas
,
D.
, 1999, “
In-Situ Straining Experiments in NiAl Along Soft Orientations, and Comparison With Atomistic Calculations
,”
Philos. Mag. A
0141-8610,
79
, pp.
723
739
.
28.
Humphreys
,
F.
, and
Hatherly
,
M.
, 2004,
Recrystallization and Related Annealing Phenomena
,
2nd ed.
,
Elsevier
,
Amsterdam
.
29.
Tóth
,
L. S.
,
Gilormini
,
P.
, and
Jonas
,
J. J.
, 1988, “
Effect of Rate Sensitivity on the Stability of Torsion Textures
,”
Acta Metall.
0001-6160,
36
, pp.
3077
3091
.
You do not currently have access to this content.