The mechanical behavior of aluminum with different alloying contents up to 1 wt percent, deformed under hot-working conditions, has been analyzed in terms of the exponential saturation equation proposed by Voce for the description of the evolution of the mechanical threshold stress, and the model advanced by Kocks for the description of the ratio, between the flow stress at any strain rate and temperature and It has been determined that the increase in the alloying content of aluminum gives rise to an increase in the mechanical threshold stress mainly due to the effect of the solute content on the saturation stress, and less markedly on the athermal stress, On the contrary, it has been found that the increase in the alloying content gives rise to a decrease of the Stage II or athermal work-hardening rate, Also, it has been concluded that the increase in the solute content of the material gives rise to a significant increase in the parameters and that enter into the expression of Therefore, the dependence of the flow stress at any temperature and strain rate with the alloying content evolves from the dependence of both and on solute concentration. Also, it has been found that, for the present analysis, the factor derived from Kocks model is more satisfactory than that derived from the Follansbee and Kocks model since the latter predicts negative values of the flow stress below approximately 10 MPa, that is to say, under conditions of elevated deformation temperatures and low strain rates.
On the Mechanical Threshold Stress of Aluminum: Effect of the Alloying Content
Contributed by the Materials Division for publication in the JOURNAL OF ENGINEERING MATERIALS AND TECHNOLOGY. Manuscript received by the Materials Division December 6, 1999; revised manuscript received January 9, 2001. Associate Editor: A. M. Rajendran.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Puchi-Cabrera , E. S., Villalobos-Gutie´rrez , C., and Castro-Farin˜as, G. (January 9, 2001). "On the Mechanical Threshold Stress of Aluminum: Effect of the Alloying Content ." ASME. J. Eng. Mater. Technol. April 2001; 123(2): 155–161. https://doi.org/10.1115/1.1354990
Download citation file:
- Ris (Zotero)
- Reference Manager