It was observed in an earlier work by Morimoto et al. [Inst. Phys. Conf. Ser. No. 70, Oxford 1984, p. 427] that the dynamic compact of an aluminium powder medium had greater flakiness and contiguity ratio than the static compact of the same density. This observed difference in micro structure is used to explain their result that the dynamic pressure of the medium is higher than the static pressure for a given density: the degree of rotation of particles during compaction is assumed to decrease for higher strain rates, because of the shorter time available, causing an increase in plastic particle deformation in the compaction direction, and increased resistance to the compaction. The normal Hugoniot equation derived, in which the mean strain rate averaged over a single steady wavefront is introduced, indicates that a rise of the normal Hugoniot with an increase in the strain rate results macroscopically from the increase in the propagation velocity of the wavefront. The multiwave Hugoniot equation is found to depend on the strain rate history of a given material. In compactions of a metal powder medium by punch impact, the wavefronts passing through the medium are approximately steady if the punch mass is sufficiently larger than the medium mass. But both the number of wavefronts arising during the compaction and the amplitudes of the strain waves, and hence the strain rate histories, vary with compaction conditions such as punch mass and initial punch velocity. This implies that a dynamic equilibrium constitutive relation for the medium will depend on the compaction conditions, and therefore cannot be determined uniquely for any two compactions.
Skip Nav Destination
Article navigation
January 1996
Technical Papers
Nonunique Dynamic Equilibrium Constitutive Relation of Metal Powder Depending on its Microstructure
Yukio Sano,
Yukio Sano
Department of Ocean Mechanical Engineering, Kobe University of Mercantile Marine, Kobe, Japan
Search for other works by this author on:
Kiyohiro Miyagi,
Kiyohiro Miyagi
Department of Mechanical Systems Engineering, University of the Ryukyus, Okinawa, Japan
Search for other works by this author on:
Peter Arathoon
Peter Arathoon
Department of Management & Information Sciences, Meio University, Okinawa, Japan
Search for other works by this author on:
Yukio Sano
Department of Ocean Mechanical Engineering, Kobe University of Mercantile Marine, Kobe, Japan
Kiyohiro Miyagi
Department of Mechanical Systems Engineering, University of the Ryukyus, Okinawa, Japan
Peter Arathoon
Department of Management & Information Sciences, Meio University, Okinawa, Japan
J. Eng. Mater. Technol. Jan 1996, 118(1): 12-18 (7 pages)
Published Online: January 1, 1996
Article history
Received:
February 7, 1994
Revised:
December 10, 1994
Online:
November 27, 2007
Citation
Sano, Y., Miyagi, K., and Arathoon, P. (January 1, 1996). "Nonunique Dynamic Equilibrium Constitutive Relation of Metal Powder Depending on its Microstructure." ASME. J. Eng. Mater. Technol. January 1996; 118(1): 12–18. https://doi.org/10.1115/1.2805926
Download citation file:
10
Views
Get Email Alerts
Cited By
Related Articles
Smooth Yield Surface Constitutive Modeling for Granular Materials
J. Eng. Mater. Technol (January,2017)
Thermoacoustic Consolidation of Metal Particles for Energy-Efficient Metal Powders Recycling in Metal Additive Manufacturing
J. Manuf. Sci. Eng (February,2025)
Dynamic Equilibrium Constitutive Relations of Copper Powder Within Dies Subjected to Mutliple Shock Compactions
J. Eng. Mater. Technol (April,1989)
Wave Propagation in Partially Saturated Soils
Appl. Mech. Rev (July,2006)
Related Proceedings Papers
Related Chapters
A Review on Prediction over Pressured Zone in Hydrocarbon Well Using Seismic Travel Time through Artificial Intelligence Technique for Pre-Drilling Planing
International Conference on Software Technology and Engineering, 3rd (ICSTE 2011)
Compressive Deformation of Hot-Applied Rubberized Asphalt Waterproofing
Roofing Research and Standards Development: 10th Volume
Effects of Compaction Temperature and Effort on the Engineering Properties of Asphalt Concrete Mixtures
Placement and Compaction of Asphalt Mixtures