On Predicting Softening Effects in Hard Turned Surfaces—Part II: Finite Element Modeling and Verification | Citedby Results | J. Manuf. Sci. Eng. | ASME Digital Collection

Skip to Main Content

Skip Nav Destination

On Predicting Softening Effects in Hard Turned Surfaces—Part II: Finite Element Modeling and Verification

J. Manuf. Sci. Eng. Aug 2005, 127(3): 484-491 (8 pages)

This article has been cited by the following articles in journals that are participating in CrossRef Cited-by Linking.

Chip control in the dry machining of hardened AISI 1045 steel

X. P. Zhang
S. B. Wu

The International Journal of Advanced Manufacturing Technology. January 2017, 88(9-12)

Experimental investigation on variation of machined residual stresses by turning and grinding of hardened AISI 1053 steel

Joseph J. Martell
C. Richard Liu
Jing Shi

The International Journal of Advanced Manufacturing Technology. January 2014, 74(9-12)

Dislocation Density and Grain Size Evolution in the Machining of Al6061-T6 Alloys

Liqiang Ding
Xueping Zhang
C. Richard Liu

Journal of Manufacturing Science and Engineering. January 2014, 136(4)

Evaluation of a three-dimensional single-point turning at atomistic level by a molecular dynamic simulation

Jing Shi
Yixin Shi
C. Richard Liu

The International Journal of Advanced Manufacturing Technology. January 2011, 54(1-4)

Two-Step Cutting for Improving Surface Integrity and Rolling Contact Fatigue Performance of Hard Machined Surfaces

Jing Shi
C. Richard Liu

Materials and Manufacturing Processes. January 2010, 25(6)

Analysis of an equivalent tool face for the cutting speed range prediction of complex grooved tools

L. Deshayes

Journal of Materials Processing Technology. January 2007, 190(1-3)