Abstract

Fused silica is the preferred material for applications requiring high temperature resistance, low thermal expansion coefficient and excellent optical properties. The machining of micro-cavities on fused silica surfaces is of particular interest for microfluidic manipulation, mechanical locking, and miniaturization of high-quality optical waveguides, but it still remains technically challenging via traditional manufacturing techniques especially for micro cavities with sharp corners. In the present study, the machining of micro-cavities in fused silica by a femtosecond laser-based method has been investigated numerically and experimentally. The effects of laser machining conditions, including laser power, laser scanning speed, laser incidence angle, and laser-off delay time, on the sidewall slope and bottom surface roughness of the micro-cavities were comprehensively investigated. The results indicated that laser power played a crucially important role in determining the sidewall slope of the micro-cavity, and the laser scanning speed had a significant influence on the bottom surface roughness. Furthermore, the sidewall slope of the micro-cavity was linearly increased as the laser incidence angle increases. By using a laser incidence angle of 10° and a laser-off delay time of 280 ms, a micro-cavity with sidewall slopes close to right angles (10°) was fabricated. This study confirms that femtosecond laser machining is an effective method for fabricating micro-cavities with sharp corners on fused silica surfaces, and the appropriate laser machining conditions should be considered based on practical application scenarios.

This content is only available via PDF.
You do not currently have access to this content.