An investigation is reported on the thermal aspects of grinding with single layer electroplated CBN wheels. The topography of these wheels is not periodically restored by dressing or truing, so the grinding behavior progressively changes as the wheel wears down. Straight surface grinding experiments were conducted to determine the effect of wheel wear and fluid flow on the grinding temperatures and energy partition. Low energy partition values of 3%–8% were obtained at temperatures below the fluid burnout limit. The energy partition results were analyzed in terms of a topographical analysis of the wheel surface and a thermal model which accounts for the removal of heat at the grinding zone by conduction to the abrasive grains and to the grinding fluid.
Thermal Aspects of Grinding With Electroplated CBN Wheels
Contributed by the Manufacturing Engineering Division for publication in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING. Manuscript received July 2003. Associate Editor: T. R. Kurtess.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Upadhyaya, R. P., and Malkin, S. (March 18, 2004). "Thermal Aspects of Grinding With Electroplated CBN Wheels ." ASME. J. Manuf. Sci. Eng. February 2004; 126(1): 107–114. doi: https://doi.org/10.1115/1.1644547
Download citation file:
- Ris (Zotero)
- Reference Manager