This paper addresses the reinforcement of photopolymers, through the addition of short glass fibers, for Rapid Layered Composite parts Manufacturing (RLCM). Novel designs for an (external) fiber-resin-mixing subsystem and a (slot-coating-based) liquid-layer-formation subsystem are presented. These subsystems, when used as integral parts of a lithography-based RLCM system, successfully cope with typical difficulties encountered in the formation of thin layers from a highly viscous fiber-photopolymer composite liquid. Axiomatic Design theory was utilized for the analysis of both subsystem designs. Verification experiments run on an RLCM system confirmed (i) the ability of the fiber-resin-mixing subsystem to supply liquid composite with specified fiber content and to avoid fiber degradation through breakage, as well as (ii) the ability of the liquid-layer-formation subsystem to form solid layers with high fiber content and of uniform thickness.
Design of a Slot-Coater-Based Layered-Composites Manufacturing System
Contributed by the Manufacturing Engineering Division for publication in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING. Manuscript received July 2001; revised Nov. 2002. Associate Editor: Y. Lawrence Yao.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Haberer, M., Zak, G., Park , C. B., and Benhabib, B. (July 23, 2003). "Design of a Slot-Coater-Based Layered-Composites Manufacturing System ." ASME. J. Manuf. Sci. Eng. August 2003; 125(3): 564–576. https://doi.org/10.1115/1.1581888
Download citation file:
- Ris (Zotero)
- Reference Manager