To understand the influence of cast iron microstructure on its machinability, a numerical model that simulates machined material on a microstructure scale was developed. This microstructure-level model assembles individual constituents into a composite material based on microstructural composition, grain size, and distribution. Extensive experimentation was performed to determine strain, strain rate, temperature, and load history dependent material properties. The purpose of this work is to validate the microstructure-level model on machining of ductile iron and two of its constituents: pearlite and ferrite. Orthogonal cutting experiments were conducted of the three materials. The measured chip morphology and machining forces were compared with the model predictions, and a good correlation between them was found.
Machining Simulation of Ductile Iron and Its Constituents, Part 2: Numerical Simulation and Experimental Validation of Machining
Contributed by the Manufacturing Engineering Division for publication in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING. Manuscript received June 2001; revised October 2002. Associate Editor: Y. Shin.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Chuzhoy, L., DeVor, R. E., and Kapoor, S. G. (April 15, 2003). "Machining Simulation of Ductile Iron and Its Constituents, Part 2: Numerical Simulation and Experimental Validation of Machining ." ASME. J. Manuf. Sci. Eng. May 2003; 125(2): 192–201. https://doi.org/10.1115/1.1557295
Download citation file:
- Ris (Zotero)
- Reference Manager