Wall nucleation experiments have been performed in a vertical annulus test section for investigation of the bubble departure diameter and bubble departure frequency. The experimental data in forced convective subcooled boiling flow is presented as a parametric study of the effect of wall heat flux, local bulk liquid subcooling, liquid flow rate, and system pressure. The data are shown to extend the database currently available in literature to a wider range of system conditions. Along with the current database in forced convective flow, the available models for bubble departure size and frequency are reviewed and compared with the existing database. The prediction of the bubble departure frequency is shown to require accurate modeling of the bubble departure diameter which has poor agreement with the experimental database.
Skip Nav Destination
Article navigation
Research-Article
Experimental Investigation of Wall Nucleation Characteristics in Flow Boiling
Caleb S. Brooks,
Caleb S. Brooks
School of Nuclear Engineering,
e-mail: csbrooks@purdue.edu
Purdue University
,West Lafayette, IN 47907
e-mail: csbrooks@purdue.edu
Search for other works by this author on:
Takashi Hibiki,
Takashi Hibiki
School of Nuclear Engineering,
e-mail: hibiki@ecn.purdue.edu
Purdue University
,West Lafayette, IN 47907
e-mail: hibiki@ecn.purdue.edu
Search for other works by this author on:
Mamoru Ishii
Mamoru Ishii
Search for other works by this author on:
Caleb S. Brooks
School of Nuclear Engineering,
e-mail: csbrooks@purdue.edu
Purdue University
,West Lafayette, IN 47907
e-mail: csbrooks@purdue.edu
Nicolás Silin
Takashi Hibiki
School of Nuclear Engineering,
e-mail: hibiki@ecn.purdue.edu
Purdue University
,West Lafayette, IN 47907
e-mail: hibiki@ecn.purdue.edu
Mamoru Ishii
1Corresponding author.
2Present address: University of Illinois at Urbana-Champaign, Department of Nuclear, Plasma, and Radiological Engineering, Talbot Laboratory, 104 South Wright Street, Urbana, IL 61801, e-mail: csbrooks@illinois.edu
Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received August 13, 2013; final manuscript received December 30, 2014; published online February 3, 2015. Assoc. Editor: Cila Herman.
J. Heat Transfer. May 2015, 137(5): 051501 (9 pages)
Published Online: May 1, 2015
Article history
Received:
August 13, 2013
Revision Received:
December 30, 2014
Online:
February 3, 2015
Citation
Brooks, C. S., Silin, N., Hibiki, T., and Ishii, M. (May 1, 2015). "Experimental Investigation of Wall Nucleation Characteristics in Flow Boiling." ASME. J. Heat Transfer. May 2015; 137(5): 051501. https://doi.org/10.1115/1.4029593
Download citation file:
Get Email Alerts
Cited By
Heat Transfer Intensification of a Confined Impinging Air Jet Via a Guiding Baffle
J. Heat Mass Transfer (July 2023)
Related Articles
Flow Boiling on Micropin Fins Entrenched Inside a Microchannel—Flow Patterns and Bubble Departure Diameter and Bubble Frequency
J. Heat Transfer (April,2010)
Nucleate Pool Boiling From Coated and Spirally Wrapped Tubes in Saturated R-134a and R-600a at Low and Moderate Heat Flux
J. Heat Transfer (April,2001)
Phase-Change Heat Transfer in Microsystems
J. Heat Transfer (February,2007)
Bubble-Induced Water Hammer and Cavitation in Microchannel Flow Boiling
J. Heat Transfer (December,2009)
Related Proceedings Papers
Related Chapters
Nucleation of Bubbles in Perfluoropentane Droplets Under Ultrasonic Excitation
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Phase Field/Fluctuating Hydrodynamics Approach for Bubble Nucleation
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment