Pool boiling heat transfer coefficients of R134a with different lubricant mass fractions for one smooth tube and five enhanced tubes were tested at a saturation temperature of . The lubricant used was polyvinyl ether. The lubrication mass fractions were 0.25%, 0.5%, 1.0%, 2.0%, 3.0%, 5.0%, 7.0%, and 10.0%, respectively. Within the tested heat flux range, from to , the lubricant generally has a different influence on pool boiling heat transfer of these six tubes.
Issue Section:
Evaporation, Boiling, and Condensation
1.
Stephan
, K.
, 1964, “Influence of Oil on Heat Transfer of Boiling Refrigerant 12 and Refrigerant 22
,” Proceedings of the 11th International Congress of Refrigeration
, pp. 369
–380
.2.
Kedzierski
, M. A.
, 2002, “Use of Fluorescence to Measure the Lubricant Excess Surface Density During Pool Boiling
,” Int. J. Refrig.
0140-7007, 25
(8
), pp. 1110
–1122
.3.
Shen
, B.
, and Groll
, E. A.
, 2005, “A Critical Review of the Influence of Lubricants on the Heat Transfer and Pressure Drop of Refrigerants. Part I. Lubricant Influence on Pool and Flow Boiling
,” HVAC&R Res.
, 11
(3
), pp. 341
–359
.4.
Kedzierski
, M. A.
, 2005, “Effect of Bulk Lubricant Concentration on the Excess Surface Density During R134a Pool Boiling
,” Int. J. Refrig.
0140-7007, 28
(4
), pp. 526
–537
.5.
Kedzierski
, M. A.
, 2007, “Effect of Refrigerant Oil Additive on R134a and R123 Boiling Heat Transfer Performance
,” Int. J. Refrig.
0140-7007, 30
(1
), pp. 144
–154
.6.
Jensen
, M. K.
, and Jackson
, D. L.
, 1984, “Prediciton of Nucleate Pool Boiling Heat Transfer Coefficients of Refrigerant-Oil Mixtures
,” ASME J. Heat Transfer
0022-1481, 106
(1
), pp. 184
–197
.7.
Kedzierski
, M. A.
, “Improved Thermal Boundary Layer Parameter for Semi-Theoretical Refrigerant/Lubricant Pool Boiling Model
,” Proceedings of the International Congress of Refrigeration
, pp. 1
–8
.8.
Kedzierski
, M. A.
, 2003, “A Semi-Theoretical Model for Predicting Refrigerant/Lubricant Mixture Pool Boiling Heat Transfer
,” Int. J. Refrig.
0140-7007, 26
(3
), pp. 337
–348
.9.
Stephan
, K.
, 1982, “Heat Transfer in Boiling of Mixtures
,” Proceedings of the Seventh International Heat Transfer Conference
, pp. 59
–81
.10.
Udomboresuwan
, A.
, and Mesler
, R.
, 1986, “The Enhancement of Nucleate Boiling by Foam
,” Proceedings of the Eighth International Heat Transfer Conference
, pp. 2939
–2944
.11.
Hsieh
, S. S.
, and Weng
, C. J.
, 1997, “Nucleate Pool Boiling Heat Transfer Coefficients of Distilled Water (H2O) and R-134a/Oil Mixtures From Rib-Roughened Surfaces
,” ASME J. Heat Transfer
0022-1481, 119
(1
), pp. 142
–151
.12.
Bell
, K. I.
, Hewitt
, G. F.
, and Morris
, S. D.
, 1987, “Nucleate Pool Boiling of Refrigerant/Oil Mixtures
,” Exp. Heat Transfer
0891-6152, 1
(1
), pp. 71
–86
.13.
Mohrlok
, K.
, Spindler
, K.
, and Hahne
, E.
, 2001, “The Influence of a Low Viscosity Oil on the Pool Boiling Heat Transfer of the Refrigerant R507
,” Int. J. Refrig.
0140-7007, 24
(1
), pp. 25
–40
.14.
Wanniarachchi
, A. S.
, Marto
, P. J.
, and Reilly
, J. T.
, 1986, “The Effect of Oil Contamination on the Nucleate Pool-Boiling Performance of R-114 From a Porous-Coated Surface
,” ASHRAE Trans.
0001-2505, 92
(2B
), pp. 525
–540
.15.
Webb
, R. L.
, and McQuade
, W. F.
, 1993, “Pool Boiling of R11 and R123 Oil-Refrigerant Mixtures on Plain and Enhanced Tube Geometries
,” ASHRAE Trans.
0001-2505, 99
(1
), pp. 1225
–1236
.16.
Curcio
, L. A.
, and Somerscales
, E. F.
, 1994, Pool Boiling of Enhanced Heat Transfer Surfaces in Refrigerant-Oil Mixtures and Aqueous Calcium Sulfate Solutions
, U.S. Department of Energy
, Washington, DC
, pp. 1
–149
.17.
Memory
, S. B.
, Sugiyama
, D. C.
, and Marto
, P. J.
, 1995, “Nucleate Pool Boiling of R-114 and R-114-Oil Mixtures From Smooth and Enhanced Surfaces—I. Single Tubes
,” Int. J. Heat Mass Transfer
0017-9310, 38
(8
), pp. 1347
–1361
.18.
Kedzierski
, M. A.
, 2001, “The Effect of Lubricant Concentration, Miscibility, and Viscosity on R134a Pool Boiling
,” Int. J. Refrig.
0140-7007, 24
(4
), pp. 348
–366
.19.
Kedzierski
, M. A.
, 2002, “Effect of Bulk Lubricant Concentration on the Excess Surface Density During R123 Pool Boiling
,” Int. J. Refrig.
0140-7007, 25
(8
), pp. 1062
–1071
.20.
Youbi-Idrissi
, M.
, Bonjour
, J.
, Marvillet
, C.
, and Meunier
, F.
, 2003, “Impact of Refrigerant-Oil Solubility on an Evaporator Performances Working With R-407C
,” Int. J. Refrig.
0140-7007, 26
(3
), pp. 284
–292
.21.
Hughes
, D. W.
, McMullan
, J. T.
, Mawhinney
, K. A.
, and Morgan
, R.
, 1984, “Influence of Oil on Evaporator Heat Transfer (Results for R12 and Shell Clavus 68)
,” Int. J. Refrig.
0140-7007, 7
(3
), pp. 150
–158
.22.
Zarnescu
, V.
, Webb
, R. L.
, and Chien
, L. H.
, 2000, “Effect of Oil on the Boiling Performance of Structured and Porous Surfaces
,” HVAC&R Res.
, 6
(1
), pp. 41
–54
.23.
Kaneko
, M.
, Sakanoue
, S.
, Tazaki
, T.
, Tominaga
, S.
, Takagi
, M.
, and Goodin
, M.
, 1999, “Determination of Properties of PVE Lubricants With HFC Refrigerants[PolyVinylEther]
,” ASHRAE Trans.
0001-2505, 105
(2
), pp. 1000
–1007
.24.
Tominaga
, S.
, 1999, “Current Trend of Refrigeration Oil for Alternative Refrigerants
,” Refrigeration
0034-3714, 74
(862
), pp. 660
–665
.25.
Fukui
, H.
, Sanechika
, K. I.
, and Ikeda
, M.
, 2000, “Novel Refrigeration Lubricants for Use With HFC Refrigerants
,” Tribol. Int.
0301-679X, 33
(10
), pp. 707
–713
.26.
Cheng
, B.
, and Tao
, W. Q.
, 1994, “Experimental Study of R-152a Film Condensation on Single Horizontal Smooth Tube and Enhanced Tubes
,” ASME J. Heat Transfer
0022-1481, 116
(1
), pp. 266
–270
.27.
Yang
, S. M.
, and Tao
, W. Q.
, 2006, Heat Transfer
, Higher Education Press
, Beijing, China
, pp. 563
–564
.28.
Gnielinski
, V.
, 1976, “New Equations for Heat and Mass Transfer in Turbulent Pipe and Channel Flows
,” Int. Chem. Eng.
0020-6318, 16
, pp. 359
–368
.29.
Masuda
, H.
, and Rose
, J. W.
, 1988, “Condensation of Ethylene Glycol on Horizontal Integral-Fin Tubes
,” ASME J. Heat Transfer
0022-1481, 110
, pp. 1019
–1022
.30.
Kline
, S. J.
, and Mcclintock
, F. A.
, 1953, “Describing Uncertainties in Single-Sample Experiments
,” Mech. Eng.
, 75
(7
), pp. 3
–9
.31.
Cooper
, M. G.
, 1984, “Saturation Nucleate Pool Boiling—A Simple Correlation
,” International Chemical Engineering Symposium Series
, 86
, pp. 785
–792
.32.
Gorenflo
, D.
, 1993, Pool Boiling in VDI-Heat Atlas
(English version), VDI-Verlag
, Dusseldorf, Germany
.33.
Spindler
, K.
, and Hahne
, E.
, 2009, “The Influence of Oil on Nucleate Pool Boiling Heat Transfer
,” Heat Mass Transfer
0947-7411, 45
(7
), pp. 979
–990
.Copyright © 2010
by American Society of Mechanical Engineers
You do not currently have access to this content.